Zhongshan Xiaolan Qixin Electronics Variable Frequency Fan Lamp Remote Control
Match coda: After hear the “beep’ sound when tum on the power,at the same time passcode match/Trun off fan” button for 3 seconds.When remote control sound twice “beep” then the code has matched
If code doesn’t match successfully, please shut off the power and wait for about 1 minute, then repeat the last action
Matters needing attention
- Receiver can not be mounted on the plane to avoid affecting the unevenness of the cover and ceiling .
- Receiver sub-inputs and outputs are strict~ prohibited from adjusting input and output pairs.
- The woli<ing voltage of this product AC -265V
- If there is a wall switch on the fan it must be on to control effectively.
- Wiring should be done according to the color of the wire and the instructions on the sleeve.
- When using the remote control please check whether the battery is installed or not Pay attention to the positive and negative poles of the battery. The control key of the handle flashes every key that is pressed
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Documents / Resources
 |
Zhongshan Xiaolan Qixin Electronics Variable Frequency Fan Lamp Remote Control [pdf] Instruction Manual JJ-F15, JJF15, 2A2IU-JJ-F15, 2A2IUJJF15, Variable Frequency Fan Lamp Remote Control, Fan Lamp Remote Control |
