Kevo FOB Configuration Instructions
For fob-and-phone systems:
Refer to the fob enrollment instructions inside the Kevo app. For fob-only systems, see page 2.
For fob-only systems
1. Use a ballpoint pen to press the enroll button on the new Kevo fob. The fob’s LED will begin to blink green.
2. Push the Program button on the back panel.
3. Hold the new fob close against the back panel. The fob’s LED will begin to blink faster. Once the Kevo beeps twice and the fob’s LED turns solid green, the fob has enrolled successfully. You may now perform the Kevo fob calibration process. See User Guide for complete instructions.
Note: beeps will only be heard if switch #3 is on.
Battery replacement
1. Use a small coin to twist and pry apart the two halves of the fob.
2. Slide battery out from between the two contacts.
Dispose of battery according to local laws and regulations.
3. Insert a new CR2025 battery, sliding it between the two contacts so that the positive face of the battery touches the positive contact.
Press the two halves of the fob back together, making sure they snap into place.
Kevo FOB Configuration Instruction Manual – Optimized PDF
Kevo FOB Configuration Instruction Manual – Original PDF
