BARCODE TECHNOLOGIES
Knowledgebase Software Labeler
Portal > Knowledgebase > Software > Labeler > Labeler – Installation – Labeler installed as
Admin says it is in Demo mode when run as the user.
Labeler – Installation – Labeler installed as Admin says it is in Demo mode when run as the user.
Internal User – 2017-04-10 – in Labeler
The user needs to be given read/write access for the directory C:\Program Files\Wasp
Technologies, and full control to the registry key HKEY_LOCAL_MACHINE\SOFTWARE\Wasp
Technologies. After that, it should allow the user to open the program correctly.
Documents / Resources
 |
Wasp Portal Knowledgebase Software Labeler [pdf] Instructions Portal Knowledgebase Software Labeler, Knowledgebase Software Labeler, Software Labeler, Labeler |
