VYNCO VFT90 Fan Run On Timer
Specifications
- Supply Voltage: Standard household voltage
- Maximum Load Rating: Refer to product label for specific load rating
- Minimum Load Rating: Refer to product label for specific load rating
- Operating Temperature: Suitable for standard room temperatures
- Timer: Adjustable timer for fan run-on duration
- Fan Motors: Compatible with Standard and Capacitor Start Fan Motors
Product Usage Instructions
Step 1: Wiring the Run On Timer
- Turn off the power at the circuit breaker.
- Follow the wiring diagram provided to wire the Run On Timer.
Step 2: Setting the Fan Run-On Time
- Set the desired run-on time using the dial on the timer.
Step 3: Enclosing the Run On Timer
- Place the Run On Timer inside the electrical flush box behind the switch plate.
- Secure the timer in place.
Step 4: Testing Safety and Operation
- After installation, test the safety and operation of the product.
FAQ
- Q: Can I adjust the run-on time of the fan?
A: Yes, you can set the desired run-on time using the dial on the timer. - Q: Is this product suitable for all types of fan motors?
A: This product is compatible with Standard and Capacitor Start Fan Motors. - Q: What should I do if I encounter any issues with the product?
A: Please contact Vynco for details on returns procedure or warranty information.
| SPECIFICATIONS | |
| Supply Voltage | 230-240V AC, 50Hz |
| Maximum Load Rating | 500W Motor / Fan |
| Minimum Load Rating | 0W |
| Operating Temperature | -10° to 60° C |
| Timer | 1 to 90 Minutes |
| Fan Motors | Compatible with Standard and Capacitor Start Fan |
WARRANTY
Please contact Vynco for details of returns procedure.
NOTE: This product contains NO user serviceable parts.
SAFETY
This product complies in full with AS/NZS 60669.2.1. This product shall be installed by a suitably qualified person in accordance with Australian and New Zealand wiring rules.
INSTALLATION INSTRUCTIONS
Always turn off the power at the circuit breaker before installation or adjusting any settings. This timer module is designed to be installed behind a wall switch.
STEP 1
Wire the Run On Timer as per the diagram.
WIRING DIAGRAM
STEP 2
Set the desired time for the fan to run on after the wall switch is turned off using the dial.
STEP 3
Enclose the Run On Timer inside the electrical flush box behind the switch plate and secure.
STEP 4
Test product safety and operation.
VYNCO INDUSTRIES (NZ) LIMITED CHRISTCHURCH
388 Tuam Street, Phillipstown, Christchurch, 8011 PO Box 9022, Tower Junction, Christchurch 8149 New Zealand
P +64 3 379 9283 F +64 3 379 6838
E sales@vynco.co.nz
VYNCO.CO.NZ
AUCKLAND
9 Levene Place, Mount Wellington
PO Box 12 249, Penrose, Auckland 1061 New Zealand
P +64 9 525 6051 F +64 9 525 5799
Documents / Resources
 |
VYNCO VFT90 Fan Run On Timer [pdf] Installation Guide VFT90 Fan Run On Timer, VFT90, Fan Run On Timer, On Timer |
