How to judge the T10 status by State LED?
It is suitable for: T10
STEP-1: T10 status LED position
STEP-2:
After the MESH network is set, if the setting is successful, the slave T10 will be in a state of steady green or orange light.
2-1. Green light indicates excellent signal quality
2-2. Orange light indicates that the signal quality is normal
Noet: In order to get a better experience, it is recommended to install the T10 to a position where the green light can be displayed.
STEP-3:
After the MESH network is set, if the setting fails, the slave T10 will be in a steady red state.
3-1. Red light indicates that MESH networking failed
Noet: It is recommended that you place the T10 next to the main T10 and try the MESH networking pairing again.
STEP-4: The light shows the status description table：
| LED Name | LED Activity | Description |
| State LED (Recessed) | Solid green | ★ The router is booting. The process finishes until the state LED blinks green.
It may take about 40 seconds; please wait. ★ It means the Satellite is synced to the Master successfully, and the connection between them is strong. |
| Blinking green | ★ The router finishes the booting process and is working normally.
★ It means the Master is synced to the Satellite successfully. |
|
| Blinking alternately
between red and orange |
The sync is being processed between the Master and Satellite. | |
| Solid red (Satellite) | ★ The Master and Satellite failed to sync.
★ The connection between the Master and Satellite is poor. Consider moving the Satellite closer to the Master. |
|
| Solid orange (Satellite) | The Satellite is synced successfully to the Master, and the connection between them is good. | |
| Blinking red | While the reset process is being proceeded. | |
| Button/Ports | Description | |
| T Button | ★ Reset Router to factory defaults:
when the router is powered on, press this button and hold it for 5 seconds until the state LED blinks red. ★ Sync Master to Satellites: press and hold this button on a router for about 3 seconds until the state LED blinks alternately between red and orange. This way, this router is set as the Master to sync to the surrounding Satellites |
|
DOWNLOAD
How to judge the T10 status by State LED-[Download PDF]
