Tenda 4G09 Router All for Better NetWorking
Set up the router
- Attach the antennas to the router,
- Insert a Mini SIM card into the slot on the bottom panel of the router.
- Use the included power adapter to connect the PWR jackof the router to a power source.
- Press the ON/OFF button down to tum on the router. Walt for a few seconds, the router Is successfully connected to the Internet, when the following indicators light up.
NOTE: If the .fJ indiCiltor does not light up, refer to 01 in FAQ to find a solution.
Customize your network
- Connect your computer to the WAN/LAN or LAN port of the router using an Ethernet cable, or connect your smart phone to the Wi-Fi network of the router using the WI-Fi Name labeled on the bottom panel of the router. There is no Wi-Fi password by default.
- Start a web browser and visit tendawifi.com.
- Follow the Quick Setup Wizard to customize yourWi-Fi network.
LED indicators
| LED indicator | Status | Description |
 |
Solid on | The router ;s powered on prope,ly, |
| m, | The router is powered oil or no, powered on properly. | |
 |
Solid on | The route,is connected to theinternet. |
| m, | No internet acce-ss is available. | |
 |
Solid on | TheWi-Fi network is enabled. |
| Blinking | The router;, performing WPS negotiation | |
| m, | TheWi-Fi networkis disab led. | |
 |
Solid on | At least one iceisconnected toa LAN port of therouter. |
| °” | No device isconnected to any LAN port of the router. | |
 |
3 bars | Excellentsignal. |
| ,l .ba,rs | Good sig nal. | |
| Fairsignal. | ||
| °” | No4G/3G sig nal. |
FAQ
Q1 :The [J LED indicator does not light up. What should I do?
A 1: Start a web browser, and access tendawifi.com to customize your network:
- If you are required to enter a PIN code to unlock the SIM card, contact your ISP for the PIN code.
- If you are required to enter APN parameters manually, enter these parameters provided by your ISP.
- If the [j LED indicator is still off after you finish the Quick Setup Wizard, your SIM card may run out of money.
If the problem persists, contact your ISP for help.
Q2: I cannot access the web UI of the router by visiting tendawifi,com. What should I do?
A2: Try the following solutions.
If you log In with a wire less device:
- Ensure that your wireless device is connected to the Wi-Fi network of the router.
- Disable the cellular network of your wireless device.
- Clear the cache of your web browser or change another web browser and try again
If you log In with a wired device:
- Check if the computer is connected to the router properly.
- Check If your computer used to set up the router obtains an IP address of 192.1 68.0.X (X ranges from 2 to 254). Otherwise, connect your computer to the router again after disconnecting from the router.
- Clear the cache of your web browser or change another web browser and try again.
If the problem persists, reset the router and configure it again.
Documents / Resources
 |
Tenda 4G09 Router All for Better NetWorking [pdf] User Guide 4G09, Router All for Better NetWorking |
