SMARTRISE Hydro Evolved Hydraulic Controller
Specifications
- Product Name: Hydro: Evolved Controller Package
- Version: 1.0
- Date: July 8, 2025
Product Usage Instructions
Package Contents
The Hydro: E volved Controller Package includes the following components:
- Unistrut
- Controller Car Top
- Inspection Box, Light Guard, 15ft CAT5
- COP SRU Board
- Enclosure Keys, USB, Hydr o: Evolved User Manual, Soft Starter User Manual
- Landing Tape
- CAT5 Package
Assembly Instructions
- Unbox the Controller Package carefully.
- Identify each component based on the provided images in the manual.
- Follow the installation steps outlined in the Hydro: Evolved User Manual.
- Connect the necessary cables and components as per the instructions.
- Refer to the Soft Starter User Manual for additional guidance if needed.
Powering On and Testing
- Ensure all connections are secure.
- Power on the Controller following the specified guidelines.
- Test the functionality of the system by performing a trial run.
- Adjust settings as necessary based on the user manual.
Date
July 8, 2025
- Version 1.0
- Summary ofChangess Initial Release
Hydro: E volved Controller Package Contents
Two-Stop Hydro: Evolved Package Contents
- This document outlines the components included in a standard two-stop Hydro: Evolved controller package from Smattrise.
2025 Smartrise Engineering, Inc. All Rights Reserved
Safety Instructions
- Read the Manual Before Use
- Carefully read and understand all instructions before installation, operation, or maintenance of the hydraulic controller.
- Keep the manual accessible for reference.
- Qualified Personnel Only
- Installation, setup, troubleshooting, and maintenance should only be performed by authorised elevator technicians.
- Do not allow untrained personnel to operate or adjust the controller.
- Power Isolation
- Disconnect all electrical power sources before servicing or wiring the controller.
- Verify that the main disconnect switch is in the OFF position before touching any internal components.
- Lockout/Tagout (LOTO)
- Follow approved lockout/tagout procedures to prevent accidental startup while performing maintenance.
- Avoid Electrical Hazards
- Do not operate the controller with damaged cables, exposed wires, or loose connections.
- Ensure all grounding connections are secure to avoid shock hazards.
- Hydraulic Safety
- Release hydraulic pressure before working on valves, hoses, or fittings.
- Wear protective gloves and eye protection when handling hydraulic fluids.
- Fire and Heat Precautions
- Keep flammable materials away from the controller and hydraulic equipment.
- Ensure adequate ventilation to avoid overheating.
- Environmental Conditions
- Protect the controller from water, excessive humidity, dust, and extreme temperatures.
- Do not store or operate in areas prone to flooding or condensation.
- Component Protection
- Never bypass or disable safety circuits such as limit switches, door locks, or emergency stop functions.
- Use only SMARTRISE-approved parts and accessories.
- Post-Maintenance Checks
- After servicing, confirm all covers are securely in place.
- Perform a controlled test run to ensure safe and correct operation before returning the elevator to service.
FAQs
Q: What should I do if I encounter issues during installation?
A: If you face any difficulties during installation, refer to the troubleshooting section of the user manual or contact Smartrise customer support for assistance.
Q: Can I extend the CAT5 cable length?
A: It is recommended to avoid extending the CAT5 cable beyond the provided length to maintain optimal performance and signal integrity.
Documents / Resources
 |
SMARTRISE Hydro Evolved Hydraulic Controller [pdf] User Guide Hydro Evolved Hydraulic Controller, Evolved Hydraulic Controller, Hydraulic Controller, Controller |