SEAVIEW ADAHALO3 Plate For Halo Open Array Radars
PARTS INCLUDED
TOOLS NEEDED
- Sudbury Elastomeric Marine
- Sealant is recommended. To
- purchase call 800-655-7922 or visit
- www.seaviewglobal.com.
INSTALLATION
- Place the ADA-R1 drill template ontop of the ADA-R1 Top Plate. Refer to the depiction of the drill template at the end of this instruction booklet.
- Mark the four #3 holes with a pen.
- Drill the four holes you just marked.
- Apply marine adhesive sealant to the lip in the center hole of the ADA-R1 Top Plate. Then route the cables through the grommet and insert the grommet into the ADA-R1 Top Plate.
- Repeat the same process with the ADA-HALO-3 adapter plate.
- Route the cables through the ADA-HALO-3 adapter plate and then mount the open array radar.
- Using your own hardware secure the open array radar to the adapter plate. (Refer to the radar manufacturer installation instructions)
- Mount the assembly to the ADA-R1 Top Plate.
- Secure the assembly using the four 3/8” x 1 1/2” bolts and washers.
NOT to scale
CONTACT
- Tel: 800-655-7922
- www.seaviewglobal.com.
- Tel: +33 4 94 53 27 70
- www.seaviewprogress.com.
- 4-07212023
- Refer to the website for the most up-to-date instructions and videos.
- WWW.SEAVIEWGLOBAL.COM.
- For Seaview Adapter Plate: ADAHALO3
Documents / Resources
 |
SEAVIEW ADAHALO3 Plate For Halo Open Array Radars [pdf] Installation Guide ADAHALO3, ADAHALO3 Plate For Halo Open Array Radars, Plate For Halo Open Array Radars, Halo Open Array Radars, Array Radars, Radars |
