Rayrun RM15 Ble Mesh Hand Held Remote Control Instruction Manual
Function
Operation
- Pair the remote to receiver
The remote controller needs to be paired to receiver for proper working. User need activate the remote before paring and each remote controller can be paired to any receiver.
To pair a new remote to the receiver, please operate with following two steps:
- Press remote
and 
key simultaneously and it will goes into the searching mode in the coming 30 seconds. - Go to the Setup page and select Add new device, then search initial device and add it to target device group.
Caution
FCC Compliance Statement: This device complies with Part 15 of the FCC rules.
Operation is subjected to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development (ISED) Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirement.
Specification
Working voltage: DC 3V, CR2032 battery
Wireless protocol: Bluetooth low energy
Frequency band: 2.4GHz ISM band
Wireless power: <7dBm
Working temperature: -20~55 C(-4~131 F)
Documents / Resources
 |
Rayrun RM15 Ble Mesh Hand Held Remote Control [pdf] Instruction Manual RM15, RM15 Ble Mesh Hand Held Remote Control, Ble Mesh Hand Held Remote Control, Mesh Hand Held Remote Control, Held Remote Control, Remote Control |