Rayrun BR03-1G LED Remote Controller
Function
Operation
Pair and unpair the remote to receiver
The remote controller needs to be paired to receiver to work. User can pair up to 5 remote controllers to one receiver and each remote controller can be paired to any receiver.
To pair or unpair remote to the receiver, please operate with following steps:
- Cut off the power of receiver and power on again after more than 5 seconds.
- Press remote
and
key simultaneously and briefly within 10 seconds after receiver powered on. - Release all keys, then press
key or 1-4 digit key within 10 seconds to pair the remote to the receiver. For
key, the receiver will be paired without group feature, for 1-4 key the receiver will be paired to 1-4 target group. - o unpair the remote from receiver, do the step 1-2 first, then release all keys and press
key within 10 seconds.
Load and save scenes
The default function of 1-4 digit keys are for scene function. User can short press 1-4 key to load scene. To save a scene, please adjust the favorite light status first, then hold press 1-4 digit key to save current status to relative scene position. After save operation, user can load the saved scene by short press the digit key.
Switch target group
To switch the target group, please press the key first, then press the target group digit key. For example, to switch to group one, please press then
key. The remote controller function will switch to the target group shortly. To restore the remote controller to all groups, please press key.
Specification
- Working voltage DC 3V, CR2032 battery
- Wireless protocol Umi protocol based on SIG BLE Mesh
- Frequency band Umi protocol based on SIG BLE Mesh
- Wireless power < 7dBm
- Working temperature -20-55 C(-4-131 F)
Documents / Resources
 |
Rayrun BR03-1G LED Remote Controller [pdf] User Manual BR03-1G LED Remote Controller, BR03-1G, LED Remote Controller, Remote Controller, Controller |
