TT MOUNT 3.0 – COMPUTER MOUNT
TT Mount 3.0 Computer Mount
STAY AERO. MOVE YOUR COMPUTER, NOT YOUR HEAD.
With the unique range of adjustability, the 76 Projects TT Mount allows the rider to maintain an aero position whilst viewing key data from their computer screen.
We recommend the mount be placed behind the hands whilst in riding position and angling the screen for optimum viewing. This will minimise head movement and helps to maintain concentration.
76 PROJECTS
- Aero position maintained
- Optimised viewing
- Perfect symmetry
- 3 way adjustability
Standard
- Negatively impacts aerodynamics (increased head movement)
- Limited ability for positioning
STEP ONE
Attach Computer to mount, undo straps and choose approx position of mount for optimum viewing.
STEP TWO
Mark position of bracket and measure width of bar centres.
Use guide to calculate screws and spacers required.
STEP THREE
Using 2.5mm allen key replace both side screws and add spacers as required.
Loosely secure screws to allow brackets to freely rotate and move during next step.
| Standard | Extra Wide | ||
| C to C (mm) | C to C (mm) | Screws (mm) | Spacers (mm) |
| 50 | 90 | 20 | |
| 54 | 94 | 20 | 2 |
| 56 | 96 | 20 | 3 |
| 60 | 100 | 25 | 5 |
| 64 | 104 | 25 | 5+2 |
| 66 | 106 | 25 | 5+3 |
| 70 | 110 | 30 | 10 |
| 74 | 114 | 30 | 10+2 |
| 76 | 116 | 30 | 10+3 |
| 80 | 120 | 35 | 10+5 |
| 84 | 124 | 35 | 10+5+2 |
| 86 | 126 | 35 | 10+5+3 |
| 90 | 130 | 40 | 10+5+3+2 |
STEP FOUR
Place mount into desired position, thread straps through each bracket.
Pull vertically to remove slack and smooth down velcro.
STEP FIVE
Align head of mount to desired angle, tighten each screw finger tight or until resistance is felt.
Re adjust straps if necessary.
Excess straps may be cut for a neat finish.
Documents / Resources
 |
PROJECTS TT Mount 3.0 Computer Mount [pdf] Instruction Manual TT Mount 3.0 Computer Mount, TT, Mount 3.0 Computer Mount, Computer Mount |