PPI HumiTherm-c Pro Temperature + Humidity PID Controller
This brief manual is primarily meant for quick reference to wiring connections and parameter searching. For more details on operation and application; please log on to www.ppiindia.net.
TEMPERATURE PARAMETERS
RELATIVE HUMIDITY (% RH) PARAMETERS:
OP3 FUNCTION PARAMETERS:
SUPERVISORY PARAMETERS:
UTILITY PARAMETERS:
COMPRESSOR OPERATION & POWER INDICATION:
ELECTRICAL CONNECTIONS
FRONT PANEL LAYOUT
Front Label
Keys Operation
| Symbol | Key | Function |
 |
PAGE | Press to enter or exit set-up mode. |
 |
DOWN | Press to decrease the parameter value. Pressing once decreases the value by one count; keeping pressed speeds up the change. |
 |
UP | Press to increase the parameter value. Pressing once increases the value by one count; keeping pressed speeds up the change. |
 |
ENTER | Press to store the set parameter value and to scroll to the next parameter on the PAGE. |
PV Error Indications
PV Error Indications For Dry Bulb Temperature (Upper Readout)
| Message | PV Error Type |
 |
Over-range (Dry-Bulb Temp. above Max. Range) |
 |
Under-range (Dry-Bulb Temp. below Min. Range) |
 |
Open (Sensor open / broken) |
PV Error Indications For Relative Humidity (RH) (Lower Readout)
| Message | PV Error Type |
 |
Over-range (Wet-Bulb Temp. above Max. Range) |
 |
Under-range (Wet-Bulb Temp. below Min. Range) |
 |
Open (Sensor open / broken) |
 |
Either Dry Bulb Temp. is below – 20.0°C or above 162.0°C. The error may also occur i f Wet Bulb depression is more then 60.0°C. |
Contact Information
101, Diamond Industrial Estate, Navghar, Vasai Road (E), Dist. Palghar – 401 210.
Sales: 8208199048 / 8208141446
Support: 07498799226 / 08767395333
E: sales@ppiindia.net, support@ppiindia.net.
Documents / Resources
 |
PPI HumiTherm-c Pro Temperature + Humidity PID Controller [pdf] User Manual HumiTherm-c Pro Temperature Humidity PID Controller, HumiTherm-c Pro, Temperature Humidity PID Controller, Humidity PID Controller, PID Controller, Controller |
