Pipishell PISRB1, PISRB2 Bench
Specifications
| Component | Specification |
|---|---|
| Vertical Supports | Material: Metal |
| Horizontal Slats | Material: Wood |
| Base Shelf | Material: Wood |
Components
- A: Vertical Supports
- B: Horizontal Slats
- C: Base Shelf
Hardware
- D1: Nut
- D2: Bolt M6 x 25mm
- E1: Screw
- E2: Screw M6 x 40mm
- F: Allen Wrench 5/32″ (4mm)
- G: Open-end Wrench
Assembly Instructions
Step 1: Assemble the Base
- Place the base shelf (C) on the floor.
- Attach the vertical supports (A) to the base using bolts (D2) and nuts (D1).
- Use the Allen wrench (F) and open-end wrench (G) to tighten the bolts.
Step 2: Attach Horizontal Slats
- Position the horizontal slats (B) between the vertical supports (A).
- Secure the slats using screws (E1 and E2).
- If the screw cannot go through the nut, use a straight screwdriver to turn the nut for alignment.
Contact Information
For assistance, contact Pipishell support:
- US/CA: 1-800-556-9829 (Mon-Fri 8am – 8pm CST)
- UK: 44-808-196-3885 (Mon-Fri 2pm – 10pm UTC)
- Email: support@pipishell.com
- Website: www.pipishell.com
FAQ
- What tools are needed for assembly?
An Allen wrench (5/32″ or 4mm) and an open-end wrench are required. - What should I do if a screw doesn’t fit?
Use a straight screwdriver to turn the nut for alignment. - How can I contact support?
Contact Pipishell via phone or email as listed in the contact information section.
Documents / Resources
 |
Pipishell PISRB1, PISRB2 Bench [pdf] User Guide PISRB1, PISRB2, PISRB1-C, PISRB2-C, PISRB1 PISRB2 Bench, PISRB1 Bench, PISRB2 Bench, Bench |
