ORTECH ERV-SC-2 ERV Screen Controller
IMPORTANT INFORMATION
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- Before connecting wires, unplug the unit or switch power off at service panel.
- Always wear safety glasses and gloves while performing these instructions.
- Wiring must be done in accordance to applicable codes and standards.
CAUTION
FAILURE TO COMPLY WITH THE FOLLOWING CAN CAUSE ERRATIC OPERATION OF THE CONTROL AND/OR UNIT.
- Never install more than one main wall control per ventilation unit.
- Keep control low voltage wiring at least 1 feet (305mm) away from motors, lighting ballast, light dimming circuit and power distribution panel.
- Do not route control wiring alongside house power wiring. Ensure the wires are securely connected.
- Use normal copper wire or low voltage wire to connect the unit with the controller, 30M length maximum or use a shielded wire, 10M ideal.
HARDWARE CONTENTS
- Screen Controller x 1
- Bracket x 1
INSTALLATION
- The opening requirements are shown in STEP 1. Depth ≤50mm.
The size of the wall opening should be slightly larger than that of pre-embedded concealed box. - Install the embedded concealed box at the opening on the wall.
- Fix the wire controller to the concealed junction box by screws.
- Wire controller bracket is fixed to the concealed junction box.
- Align the product positioning holes with the wire controller bracket snap and push the product downward to secure the product fixed to the bracket.
- Installation complete.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
WIRING DIAGRAM
ORTECH reserves the right to modify at any time, without notice, any or all of our product’s features, designs, components and specifications to meet market changes.
CUSTOMER SUPPORT
www.ortechindustries.ca
1.888.543.6473
13376 Comber Way, Surrey, BC V3W 5V9
205 Summer lea Road, Brampton, Ontario
info@ortechindustries.com
604.543.6473
Documents / Resources
 |
ORTECH ERV-SC-2 ERV Screen Controller [pdf] Instruction Manual ERV-SC-2, ERV-SC-2 ERV Screen Controller, ERV-SC-2, ERV Screen Controller, Screen Controller, Controller |