Instructions
PALMA2 Mobile ePaper
| ① Power button ② Volume/page-turn buttons ③ Mic ④ USB-C Port ⑤ Customizable Function Button |
⑥ MicroSD card slot ⑦ Light sensor ⑧ Speaker ⑨ Rear camera ⑩ LED Flash 11 Speaker |
a. BOOX Device
b. Quick Start Guide & Warranty Card
c. USB-C Cable
QUICK START GUIDE
Turn on the device: Hold down the power button for 2-3 seconds.
Charging: When the battery is low or the device can not be turned on, please connect your BOOX with a PC or an Adaptor to charge it.
Firmware update: OTA update on the device.
To force shutdown, please hold the power button for about 15 seconds. You can read the full version of the User Manual in the Settings menu of the device.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure Statement
SAR tests are conducted using standard operating positions Acco rding FCC standards with the device transmitting at its highest certified power lev el in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the m aximum value. This model product has been tested and meets the FCC RF exposur e guidelines with the test distance 0mm for body worn. The highest SAR1g value is 0.795 W/Kg. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with RF exposure requirements, and should be avoided
Documents / Resources
 |
onyx PALMA2 Mobile ePaper [pdf] Instructions XR3-PALMA2, XR3PALMA2, palma2, PALMA2 Mobile ePaper, PALMA2, Mobile ePaper, ePaper |