Newegg UN-102 IDE/FDD Controller 
Card User Manual

Information in this manual is subject to change without notice
IBM, IBM PC/AT are trademarks or registered trademarks of International Business Machine Corp.
386 Is a trademark or registered trademark to Intel Corp.

1. INTRODUCTION

This floppy disk controller Is fully compatible with IBM PC/AT. It can be connected to two floppy disk drives. Floppy disk drives that are supported include 360KB/1.2MB(5.25’1 or 720KB/1.44MB(3.5″). The IDE hard disk controller Is an advanced design wth roost to the controller circuitry embedded inside lye hard disk itself. Such a design improves reliability, reduces power and eliminates conventional Drive-Controller compatibility problems.

The floppy disk controller can be set to primary or secondary port with jumper J4 However, your system must have a BIOS that can suppor14 floppy disk drives If you do choo a sector, dray port, The disk Cormier can be disabled with J3.

2. LAYOUT OF IDE/FDD CONTROLLER CARD

3. CABLE DESCRIPTION

3.1 FLOPPY CABLE (34-woy)

4. JUMPER SETTING

5. INSTALLATION

1. Prepare your AT, 386 or compatible system. Power off the system and all related equipment.
2. Remove power cord from the system (safety first) and disconnect all other cables from the system (label them ii necessary).
3. Remove system unit cover for access.
4. Set Jumpers on UN-102.
5. Connect 34-way Floppy Disk cable to J2 (Pin 1 of cable has color strip) and connect 40- way Hard Disk cable to J1. {Pin i of cable has color strip)
6. Connect Hard Disk Active LED cable to JP1 . (Pin 1 of JP1 Is closer to IC U2)
7. Select a slot that is convenient for cable arrangement. Remove the screw or the back panel and pull it up.
8. Align and Insert UN-102 into the slot False the screw on the back panel.
9. Replace and secure the cover of the. System unit and re-connect the power cord and other externa cables.

6. CONNECTOR PIN ASSIGNMENTS

6.1 FLOPPY CONNECTOR (J2)

6.2 IOE HARO DISK CONNECTOR (J1 )

6.3 Hard Disk Active LEO cable connector – JP1

Pln1 Cathode Pln2 Anode

UN-102
First Edition 7 /91
Part no. 043033
Size: 9.8 X 14.0 CM

Primed In Hong Kong

Documents / Resources

Newegg UN-102 IDE/FDD Controller Card [pdf] User Manual UN-102 IDE FDD Controller Card, UN-102 IDE, FDD Controller Card, Controller Card, Card

References

• User Manual