Mr Pen Skateboard Griptape With Next Level Durability

Installation Instruction

1. Remove the protective film of the grip tape before you install it.
   • Description: The image shows a person holding a strip of grip tape with one hand while peeling off the protective film with the other hand.
2. Remove the protective film of double-sided adhesive on the back.
   • Description: The image shows a person holding the grip tape and peeling off the protective film from the double-sided adhesive on the back of the tape.
3. Start wrapping from the knob.
   • Description: The image shows a person starting to wrap the grip tape around the knob of a racket handle.
4. Continue to wrap while stretching the tape slightly to the racket handle.
   • Description: The image shows a person wrapping the grip tape around the racket handle, ensuring the tape is slightly stretched for a snug fit.
5. After finishing wrapping, trim the tape for an oblique angle.
   • Description: The image shows a person using scissors to trim the end of the grip tape at an oblique angle after wrapping it around the racket handle.
6. Fasten the top of the grip tape with the finishing tape attached.
   • Description: The image shows a person fastening the top of the grip tape with a piece of finishing tape to secure it in place.

Documents / Resources

Mr Pen Skateboard Griptape With Next Level Durability [pdf] Installation Guide Skateboard Griptape With Next Level Durability, Skateboard Griptape With Next Level Durability, Griptape With Next Level Durability, Next Level Durability, Durability

References

• User Manual