User manual
model: 9900NFC
9900 NFC Module
Modulation mode: ASK
Power supply voltage: 5V±5%
Working range of Atmosphere Temp: 0°C~+70°C
Software Version: V1.0
Hardware Version: V1.0
This NFC module can work in two Work Mode modes:
NFC reader: Reads and writes NFC cards.
NFC card: Can be read by the NFC reader
Main chip of this module is PN1750, from NXP. The module operates at a frequency of 13.56 MHz.
The digital interface of this module consists of 5V power supply and I2C communication port. The host can send instructions to this module through the I 2C bus to implement the functions of NFC reader and card.
The module is limited to OEM installation only.
This product is mounted inside of the end product only by professional installers OEM. They use this module with changing the power and control signal setting by software of end product within the scope of this application. End user cannot change this setting.
This device is intended only for OEM integrators under the following conditions:
- The antenna specification listed below:
Ant. Type Operation Frequencies (MHz) PCB Print Antenna 13.56 - The transmitter module may not be co-located with any other transmitter or antenna.
As long as these two conditions are met, further transmitter test will not be required. However, integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
The OEM integrator has to be aware no to provide information to the end user regarding how to install or remove this RF module in the user manual of the end product with integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
If the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: ZLZ-9900NFC”
When the module is installed inside another device, the user manual of this device must contain below warning statement:
Federal Communication Commission Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
That separate approval is required for all other operating configurations, including portable configurations with respect to Part 2.1093 and different antenna configurations.
Documents / Resources
 |
Mindray 9900 NFC Module [pdf] Instructions 9900, 9900 NFC Module, NFC Module, Module |