LOKK Latch CSI724 Gate Locking Latch Installation Guide
Not suitable for child safety gates – Use MagnaLatch instead.
Tools
5/32” (4mm) 1/2” (13mm)
31/2” (90mm)
#2
File
Installation Instructions
GAP VARIANCE
- FIT THE TRIM COVERS
Trim covers cannot be removed once fitted. - INSERT PUSH ROD FIRMLY INTO HOUSING UNTIL GROOVE IS ALIGNED WITH HOUSING
- DRILL PUSH-ROD THROUGH-HOLE INTO GATE
#2 Refer to B on back page
* Refer to A on back page
- FASTEN LATCH TO GATE
- SAW PUSH-ROD FLUSH WITH FITTING JIG
- Use file to ensure push rod is square and does not extend beyond post more than 3/16” (5mm).
Do NOT cut push-rod at an angle
- INSTALLING EXTERNAL ACCESS KIT (EAK)
Ensure housing is in vertical position before fitting the Push Rod. - ALIGN AND FASTEN THE EAK
Firmly tighten screws on all components.
- INSERT DRESS CAPS
- MARK AND INSTALL KEEPER TO POST
- CHECK VERTICAL ALIGNMENT
Adjust keeper so that the raised bump aligns with same on latch - WIND SCREW TO JOIN COMPONENTS
- CHECK HORIZONTAL ALIGNMENT
Adjust keeper so that the raised bump aligns with same on latch.
Removing Screw Covers (if necessary)
- Insert blade horizontally underneath cover
- Twist screwdriver and remove
- See Step 8 to replace
Tube helps protect locks from corrosion. NOT mandatory.
GATE FRAME
Hole # 2 on fitting jig is for recessing side fixing legs on Latch for wood gates
MAINTENANCE: REMOVE KEY FROM LOCK AFTER USE. Do not lubricate with petroleum-based products. Ensure all screws are tightened firmly and that the latch is kept free of ice, dirt and other debris which could impair performance. Periodic horizontal and/or vertical adjustment may be required.
For a downloadable Adobe Acrobat (PDF) version of our Limited LIFETIME WARRANTY, go to our website at www.ddtechglobal.com
www.LinearGateOpeners.com
800-878-7829
Sales@LinearGateOpeners.com
Documents / Resources
 |
LOKK Latch CSI724 Gate Locking Latch [pdf] Installation Guide CSI724 Gate Locking Latch, CSI724, Gate Locking Latch, Locking Latch |
