LC-POWER LC-CC-85 CPU Cooler User Manual

Contents hide

1 LC-POWER LC-CC-85 CPU Cooler

2 Specification

3 Installation

4 Documents / Resources

4.1 References

5 Related Posts

LC-POWER LC-CC-85 CPU Cooler

Thank you for choosing a LC-Power product, please read the manual carefully before installation, thank you!

CPU cooler

Specification

Dimension: 104 x 100 x 45mm
Weight: 147g

Heat sink: Aluminium
Bearing: Hydraulic

Fan Size: 80 × 80 x 25mm
Fan Speed: 800 – 2200 RPM

Air Speed: 11.62 – 32.45CFM
Connector: 4 pin PWM

Socket: Intel 1851/1700/1200/1156/1155/1151/1150 AMD AM5/4/3/3+/2/2+/FM/2/1

Before installation, please confirm that the CPU cooler is suitable to cool down the heat of your individual CPU model.

Basic information
Please make sure that the thermal paste is evenly distributed on the top of your CPU in case it has not already been applied to the cooler heat sink bottom directly.

Installation

Intel LGA 1851/1700 socket mainboard installation instructions

Please push plastic pin A to the 1851/1700 mark direction as shown’ on picture 1-1.
Confirm that the direction of the 4 plastic pins is right, then press the whole set of plastic clips into the installation hole on the mainboard, then insert the plastic rivets to fix them as shown on picture 1-2.

Intel LGA 115X/1200 socket mainboard installation instructions

Please pull plastic pin A to the 1200 mark direction as shown on picture 1-1. 2.
Confirm that the direction of the 4 plastic pins is right, then press the whole set of plastic clips into the installation hole on mainboard, then insert the plastic rivets to fix then as shown on picture 2-2.

Connect the fan cable connector to the power socket on the mainboard where marked as „CPU FAN”. Start your computer and check if everything works properly and if the CPU is properly cooled, then finish installation.

AMD FM1/2/AM2/3/4/5 socket mainboard installation instructions

Put the CPU cooler to the center of the plastic clip. Hitch the tail of the cooler clip to the plastic clip. Then move the other side of the cooler clip and hitch it to the other side of the plastic clip.
Connect the fan cable connector to the power socket on the mainboard where marked as “CPU FAN”. Start your computer and check if everything works properly and if the CPU is properly cooled, then finish installation.