KONDATOR 935-PM50 Built-in Power Socke
INSTALLATION INSTRUCTION
- A- Installation into a round hole
B- Installation into a tailored hole
CONTENT
- 1A
- DRILL
- Drill a hole in the table.
- 2A)
- INSERT Insert Powerdot into the hole and feed the power plug through the table and the plastic fastening nut.
- 3A
- TURN CLOCKWISE& PLUGIN Turn the plastic fastening nut as far up the thread as possible. Make sure it has been thoroughly tightened. Lastly, plug the Schuko plug into the wall socket.
- – 1 Schuko socket
- w 1250 mm cable
- 1B
- MILL
- Mill a hole in the table.
- 2B
- INSERT Insert Powerdot into the hole and feed the power plug through the table and the plastic fastening nut.
- 3B
- Turn the plastic fastening nut as far up the thread as possible. Make sure it has been thoroughly tightened. Lastly, plug the Schuko plug into the wall socket. TURN CLOCKWISE & PLUGIN
- Kondator AB, Energivägen 8 – Box 121, SE-135 23 TYRESÖ, SWEDEN
- www.kondator,se
Documents / Resources
 |
KONDATOR 935-PM50 Built-in Power Socket [pdf] Installation Guide 935-PM50, Built-in Power Socket, Power Socket, Built-in Socket, Socket, 935-PM50 Power Socket |
