KLEIN TOOLS 54802MB MODbox Two Drawer Rolling Tool Box
TO REMOVE THE TELESCOPING HANDLE
STEP 1: While facing the backside of the Rolling Toolbox, collapse the handle by depressing the orange button.
STEP 2: Use your index finger and thumb to pull each of the two black tabs located on each of the arms of where the telescoping handle meets the box. Tabs should be pulled until a red indicator reading, “Unlocked” is visible.
STEP 3: Using the center cross brace of the handle, pull up on the handle assembly until it slides out of the receiving slots
in the rolling box. Note: if toolbox is empty, you may need to brace it with your foot on the back stowage ledge
while pulling up the handle.
TO REATTACH THE TELESCOPING HANDLE
STEP 1: Slide the telescoping arms back into their respective slots until fully seated. Ensure the correct side of the handle is facing out. The orange button will be visible from the back.
STEP 2: Use the palm of your hand to push both black tabs back into place, until the red “Unlocked” is no longer visible.
STEP 3: Pull up on the handle until fully extended and handle locks into place.
CUSTOMER SERVICE
KLEIN TOOLS, INC.
450 Bond Street, Lincolnshire, IL 60069
1-800-553-4676
customerservice@kleintools.com
www.kleintools.com
©2025 Klein Tools, Inc.
Lincolnshire, IL 60069
Documents / Resources
 |
KLEIN TOOLS 54802MB MODbox Two Drawer Rolling Tool Box [pdf] Instruction Manual 54801MB, 54802MB, 54802MB MODbox Two Drawer Rolling Tool Box, MODbox Two Drawer Rolling Tool Box, Drawer Rolling Tool Box, Rolling Tool Box, Tool Box |