S1-TTlock
1. Check Foundation Accessories
After unpacking the product, check whether the following accessories are complete.
Front handle x1 Key X2 Lock screw X2
Rear handle x1 Batteries X4 (Not included)
Lock body x1 Long screw X2 Stud X2
Latch piece x1 Hexagon wrench X1 Pin X1
Latch cover X1 Hollow square steel X1
2. Installation Step Diagram
1. Install the lock body
Put the lock body into the corresponding slot and fix the upper and lower screws.
2. Install front handle
Secure the two nut posts to the front handle.
Put the power cord on the front handle through the square steel bar.
Note: square steel is put to the bottom
The square steel passes through the square steel hole of the lock body, Secure the handle.
3. Install the rear handle
Loosen the screws of the rear cover plate with a hexagon wrench and remove the rear cover plate.
Put one end of the power cord through the center hole of the rear handle.
Align the square steel bar, tighten it with long screws, and fix the rear handle.
4. Install the battery
Plug in the power cord and install the battery.
Note: when connecting the power line, the red mark on the terminal block is inserted in the same direction as the port red mark.
Fasten the rear cover plate and fix the screws of the rear cover plate.
5. Complete and test
After installation, check the door opening
TT LOCK USER MANUAL
Fingerprint open the door
Password open the door
APP open the door
Key to open the door
APP Store Google Play
The software (iOS version) can be downloaded from the APP store, and the Android version can be downloaded from the application store of Google play.
Registration And Login By APP
- User can use phone number or email for registration which supported 159 countries.
- Verification code will send to phone or email.
- When the registration is successful, it will jump to home page.
Key Binding No Key Binding
Add Lock By APP
Add a Lock Select “Door Lock” Light Up Keypad
Select Lock Enter Name Completed
Send Key BY APP
The user can send the bluetooth key to others with time, permanent. one-time or recurring key. The administrators can manage all the keys they send out, including clearing keys, resetting keys, sending keys adjusting the time limit of the keys,and viewing the access records.
Fingerprints Adding Passcodes/Passwords Adding Records
Passage Mode
- Passage mode can be set by days, start time or end time. After the passage mode is activated, everyone can directly unlock the door without any access permission. The passage mode can be turned off by clicking again.
- Open the lock by fingerprint (this fingerprint must input at lock), press the digit #123#, then the passage mode is on, freely to in and out. How to off this passage mode, just scan the fingerprint again,then it will be locked.
Restore Factory Settings
- Long press the back panel setup button for 5 seconds to restore the factory settings
- Delete the device at TT lock app, after click the delete, it need fill your register password and also press # at the panel of lock, then app will show deleted successfully
- Setup button
| 
|
We are so glad that you are happy with our products
We strive to provide better products and services
Share your experiences with your family and friends
Share your experiences for help
Share your photo on Instagram #kisstysmart
Installation video: Search kisstysmart at Youtube or Instagram
Email for service: kissty2021@126.com
Documents / Resources
 |
KISSTY S1-TTlock Smart Fingerprint Door Lock [pdf] Instruction Manual S1-TTlock Smart Fingerprint Door Lock, S1-TTlock, Smart Fingerprint Door Lock, Fingerprint Door Lock, Door Lock, Lock |
