JONSBO D40 Computer Case
Contents
hide
Package Content
| Image | Q’ty | Used for | ||
| A |  |
13 | Screws- PSU+MB | |
| B |  |
13 | Washer | |
| C |  |
8 | Screws – 2.5″ SSD | |
| D |  |
4 | Rubber grommet | |
| E |  |
6 | Screws – 3.5″ HOD | |
| F |  |
4 | Screws – 2.5″ SSD | |
| G |  |
4 | Screws – 2.5″ SSD | |
| H |  |
1 | Spare Standoff | |
| I |  |
1 | Hex Wrench | |
| J |  |
5 | Cable tie | |
| K |  |
1 | Velcro | |
Connectors
 |
HD AUDIO |  |
PWRSW |
 |
HDD LED | ||
 |
USB-8.2-Gent |  |
PWRLED |
Exploded view
Parts
- Side Panel
- Top cover
- Chassis
- SSD Bracket
- Air Filter
installation Guide
Remove covers
- Loosen the screws, and then pull the top cover back to loosen it
- Loosen the side panel screws, and then lift the side panel
Motherboard installation
Insert the MB 10 Shield, and then place the motherboard on the corresponding position and secure with screws
GPU/Add-on card Installation
- Remove the PCI bracket
- Install the GPU/PCI add-on card
PSU Installation
- Remove SSD bracket
- Place the PSU on the corresponding position and secure with screws
HDD/SSD Installation
3.5″ HDD hard drive mounting position compatible with 2.5″ SSD|
SSD Installation
Pre-mount rubber grommet with screw to 2.5″ SSD, and then insert it into SSD bracket slot
Remove the bottom rubber grommets before installing case fan
Finish installation
- Insert the side panels to case, secure them with screws.
- Place the top cover into slots, push ii towards the front, fix it with screws
Additional Information
| CPU Cooler Limitations | 168mm H Max. |
| Graphics Card Limitations | 305(PSU >170MM L)~355mm L Max. |
| Power Supply Limitations | ATX PSII 280mm L Max. |
| Motherboard Limitations | ATX / M-ATX / ITX |
|
Radiator Limitations |
TOP: 240mm x 1, BOTTOM 240mm x1, Rear 120mm x 1 |
| Drive baysl | 2.5″ SSD x 4 / 2.5″ SSD x3+3.5″ HDD x 1 |
Documents / Resources
 |
JONSBO D40 Computer Case [pdf] User Manual D40 Computer Case, Computer Case, D40 Computer, Computer, D40, Case |
