JLab TWS Earbuds Pairing Guide
Welcome to your new pair of Jlab true wireless earbuds along with the ear buds. In case you will find a quick start guide and different sized ear tips. Be sure to take them outbefore recycling the 100% recyclable box.
Whats In The Box
CONNECTIONG BLUETOOTH DEVICE
First Time Set Up
open the case and remove the pull tab, then take the earbuds out of the case.
Once out one earbuds blinks blue and white indicating that they are ready to pair to your device,
Turn on Bluetooth on your device and select Jlab go a pop a voice prompt saying Bluetooth connected followed by blinking white lights on both earbuds
will indicate that you are connected.
Now, when the earbuds are taken out of the case, they will auto power on and reconnect to your device.
If you are connecting to a new device or having trouble connecting, make sure Bluetooth is turned off or disconnected on any previously connected device.
Then take the Earbuds out of the case and they will automatically enter Bluetooth pairing.
Select your Jlab Earbud to reconnect
TROUBLESHOOTING
Connection failure or the earbuds have disconnected from each other.
With the earbuds in the charging case,……….
Enter your Bluetooth settings on your device and forget the JLab Earbuds.
Leave both ear buds in the charging case. And on one ear bud quickly tap the touch sensor seven times.
The light on the ear bud will blink blue four times and then turn off repeat with the other ear BD.
Quickly tapping the touch sensor seven times.
Then, Take both Earbuds out of the case and wait for one Earbud to turn solid white and the other to blink blue and white.
You are now ready.
Reconnect your Bluetooth device.
