HUUM-logo

HUUM 16204 Drop Embedding Flange

HUUM-16204-Drop-Embedding-Flange-product

Installation

HUUM-16204-Drop-Embedding-Flange-fig-1

Dimension

HUUM-16204-Drop-Embedding-Flange-fig-2

EMBEDDING FLANGE

  • Place the plates of embedding flange on the desired place of the boarding. Make sure that the end edges of the embedding flange are against the wall.
  • Mark the inner edge of the embedding flange on the boarding of the sauna platform.
  • Follow the marked line and draw the second contour 52 mm outwards. We recommend using a 52 mm wide wooden block for that purpose.
  • Cut the wider contour by following the aperture.
  • Attach the brackets of the embedding flange to the plates by using bolts and nuts.
  • Install the embedding flange to the cut aperture, adjust the cut edge, if necessary.
  • Attach the brackets to the boards of the platform with screws.
  • You can now install the DROP heater. Follow the minimum height from the figure below:

#huumsauna
www.huum.eu

Documents / Resources

HUUM 16204 Drop Embedding Flange [pdf] User Manual
16204 Drop Embedding Flange, 16204, Drop Embedding Flange, Embedding Flange, Flange

References

Leave a comment

Your email address will not be published. Required fields are marked *