CONTROL02 Remote Control
Specifications:
- Battery: 3.7V 180mAh
- Dimension: 86x38x18mm
- Net Weight: 45g
Product Information:
The product is a dimmable light source controller that allows
users to adjust parameters such as color temperature (CCT), hue,
saturation, and intensity (HSI) of the lighting. It features
multiple keys for power control, dimming adjustments, and menu
navigation.
Product Usage Instructions:
Power On/Off and Dimming:
To power on/off the device and access the dimming settings:
- Short press KEY1: Powers the device on/off and enters the
dimming page. - Short press KEY3: Enters the dimming page. Press on the dimming
page to switch between different light sources if available.
In the power-off state:
- Short press KEY2: Enters the menu page.
- Short press on CCT page: Switches between luminous flux (lm)
and color temperature (CCT) parameters. - Scroll the knob: Adjusts the current parameters.
Main Dimming Pages:
In the power-on state:
- Long press KEY1: Switches to the CCT/HSI main page for colored
light adjustments. - Long press KEY2: Switches to the HSI main page for hue,
saturation, and intensity adjustments.
FAQ:
Q: What should I do if the device does not respond to key
presses?
A: If there is no response to key presses for more than 1
minute, the device will auto power-off. Simply power it back on to
resume operation.
Q: How can I adjust the dimming parameters precisely?
A: Use the knob to scroll and adjust the current parameters for
precise dimming control.
100%
Operation introduction
KEY3
KEY2 KEY1
KEY1/CCT/HSI Short press KEY1: Power on/off. After power-on, enter the dimming page (display the CCT/HSI page as it was before power-off).
KEY3
/ Short press KEY3: Enter the dimming page. Press on the dimming page to switch the
dimming light source (if there are floodlight/spotlight options).
2700K
KEY3
KEY2
KEY1
Power-off state
KEY2
Short press KEY2 to enter the menu page.
CCTlmcct Short press: Switch dimming parameters. (On the CCT page, switch between lm and
CCT parameters.)
Scroll the knob: Adjust the current parameters.
(1CCT)
Power-on state, Main dimming page (CCT page) (Auto power-off if there is no operation for more than 1 minute)
CCT/HSI(
Long press to switch to the CCT/HSI main page (if there is colored light).
I 100% S 100 H 360
KEY3
KEY2
KEY1
HSI) (1
Power-on state, Main dimming page (HSI page) (Auto power-off if there is no operation for more
than 1 minute)
HSIH,S,I Short press: Switch dimming parameters. (On the HSI page, switch between H, S, and
I parameters.)
Scroll the knob: Adjust the current parameters.
Battery Dimension Net Weight
3.7V 180mAh 86x38x18mm 45g
FCC warning statements:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement.
Documents / Resources
 |
Hobolite CONTROL02 Remote Control [pdf] Instruction Manual CONTROL02 Remote Control, CONTROL02, Remote Control, Control |