HDWR AC800LF RFID Card and Password Access Control Reader
Specifications
- Warranty: 1 year
- Device Type: RFID reader with access control
- Operating frequency: 125 kHz
- Verification Type: RFID Card, Password
- Response Speed: Less than 0.2 seconds
- Reading distance: 5-10cm
- Light Signal: Bi-color LED
- Beep: Built-in speaker (buzzer)
- Communication Distance: 100 meters
- Data transfer: real-time
- Operating voltage: DC 9V – 16V, standard 12V
- Working Current: 70mA
- Interface: Wiegand 26 or 34
- Operating Temperature: -25º C – 75º C
- Operating Humidity: 10%-90%
- Product dimensions: 8.6 x 8.6 x 1 cm
- Package dimensions: 10.5 x 9.5 x 2.8 cm
- Product weight: 100 g
- Package weight: 300 g
Product Usage Instructions
Set contents:
- RFID Access Control Reader
- Jumper cables
- Special Key
- Manual
Features:
- Compact shape and elegant design
- Can be combined with an electric or electromagnetic lock or a time recorder
- Verification via RFID card and password
Installation:
- Use a Phillips-type screwdriver to loosen the screw between the panel and the motherboard.
- Attach the motherboard to the sidewall with a plastic plug and screws.
Connection Diagram:
| Wiegand 26/34 | RS485 | RS232 | |||
| Red | DC 9V –
16V |
Red | DC 9V –
16V |
Red | DC 9V –
16V |
| Black | GND | Black | GND | Black | GND |
| Green | D0 | Green | 4R+ | ||
| White | D1 | White | 4R- | White | TX |
| Blue | LED | ||||
| Yellow | BEEP | ||||
| Grey | 26/34 | ||||
| Orange | Bell | ||||
| Brown | Bell | ||||
Installation Comments:
- Check the electrical voltage (DC 9V – 16V) and distinguish the positive anode and cathode of the power supply.
- When external power is used, we suggest using the same GND power supply with the controller panel.
- The cable connects the reader with the controller, we recommend using 8-wire twisted pair cable. The Data1Data0 data cable is twisted pair cable, we suggest that the cross-sectional area should be at least 0.22 square millimeters. The length should not exceed 100 meters.
Shielded wire connects GND, and two-core cable will improve the reader’s working efficiency (or the use of a multi-core AVAYA cable).
FAQ
Q: What should I do if the LED indicator is not working?
A: Check the power supply connection and ensure the correct wiring according to the connection diagram provided in the manual.
Q: Can I use a different power supply voltage other than DC 9V – 16V?
A: It is recommended to use the specified power supply voltage range to ensure proper functioning of the access control reader.
Q: How many users can be registered with this access control reader?
A: The user capacity may vary based on the specific model. Please refer to the product specifications or contact customer support for more information.
Documents / Resources
 |
HDWR AC800LF RFID Card and Password Access Control Reader [pdf] User Manual AC800LF, AC800LF RFID Card and Password Access Control Reader, RFID Card and Password Access Control Reader, Password Access Control Reader, Access Control Reader, Control Reader |