User Manual for HDWR models including: AC800LF, AC800LF RFID Card and Password Access Control Reader, RFID Card and Password Access Control Reader, Password Access Control Reader, Access Control Reader, Control Reader
User Manual RFID Card and Password Access Control Reader SecureEntry-AC800LF Table of contents Specifications: ............................................................................................................................................................... 3 Set contents: ................................................................................................................................................................... 4 Features: ............................................................................................................................................................................ 4 Installation........................................................................................................................................................................ 5 Connection diagram................................................................................................................................................ 5 Comments ....................................................................................................................................................................... 5 2 Specifications: · Warranty: 1 year · Device Type: RFID reader with access control · Operating frequency: 125 kHz · Verification Type: RFID Card, Password · Response Speed: Less than 0.2 seconds · Reading distance: 5-10cm · Light Signal: Bi-color LED · Beep: Built-in speaker (buzzer) · Communication Distance: 100 meters · Data transfer: real-time · Operating voltage: DC 9V - 16V, standard 12V · Working Current: 70mA · Interface: Wiegand 26 or 34 · Operating Temperature: -25º C - 75º C · Operating Humidity: 10%-90% · Product dimensions: 8.6 x 8.6 x 1 cm · Package dimensions: 10.5 x 9.5 x 2.8 cm · Product weight: 100 g · Package weight: 300 g 3 Set contents: · RFID Access Control Reader · Jumper cables · Special Key · Manual Features: · Compact shape and elegant design · Can be combined with an electric or electromagnetic lock or a time recorder · Verification via RFID card and password 4 Installation Use a Phillips-type screwdriver to loosen the screw between the panel and the motherboard. Next, attach the motherboard to the sidewall with a plastic plug and screws. Connection diagram Wiegand 26/34 Red DC 9V 16V Black GND Green D0 White D1 Blue LED Yellow BEEP Grey 26/34 Orange Bell Brown Bell RS485 Red DC 9V 16V Black GND Green 4R+ White 4R- RS232 Red DC 9V 16V Black GND White TX Comments 1. Check the electrical voltage (DC 9V - 16V) and distinguish the positive anode and cathode of the power supply. 2. When external power is used, we suggest using the same GND power supply with the controller panel. 3. The cable connects the reader with the controller, we recommend using 8-wire twisted pair cable. The Data1Data0 data cable is twisted pair cable, we suggest that the cross-sectional area should be at least 0.22 square millimeters. The length should not exceed 100 meters. 5 Shielded wire connects GND, and two-core cable will improve the reader's working efficiency (or the use of a multi-core AVAYA cable). 6Microsoft Word 2019