730182 – FUSION 8×8 STARTING BLOCK
INSTRUCTIONS
730182C Fusion F8 Starting Block
Pedal pads are available in the following colors:
- Royal Blue
- Red
- Orange
- Black
- Green
Precise and consistent foot placement is ensured using the integrated pedal markings.
Pedals are adjustable to 30°, 40°, 50°, and 60° settings. Angled spikes in the base of the pedals guarantee a start with absolutely no slipping. Built in handle allows for easy carriage.
The FUSION starting block is shipped unassembled.
The following tools are needed:
- Needle Nose Pliers
- Spike Wrench
- Allen Key (provided)
- Pedal pads
Set the angle of the pedal to the 60 position.
Insert the tabs on the pedal pad into the holes in the pedal plate.
Use one hand to press on the pedal pad. Use the other hand to gently pull the tabs through the holes with needle nose pliers.
Gently wiggle the tab to help it through the hole. Be careful not to pull the tab off of the pedal pad.
- False start bracket
Fasten the false start bracket to the back of the rail with the flat head screw provided.
Make sure that the “teeth” of the rail are pointing away from the false start bracket.
- Pedals
Slide each pedal onto the rail so that the pedal pad is facing towards the open end of the rail.
- Handle
Fasten the handle to the front of the rail with the flat head screw provided.
- Spikes
Flip the starting block over and install the spikes into the bottom of each pedal.
Replacement Parts
 |
7301821C02 – Royal Blue 7301821C03 – Red 7301821C05 – Orange 7301821C12 – Black 7301821C15 – Green |
 |
REPL00043 Pedal Set Screws QTY 10 |
 |
7301813 Rail |
 |
73016504 Spike Kit includes 16 spikes |
 |
7301822 Includes: Right & Left Pedal with Pedal to Rail Connectors Handle & Rear Bracket Handle & Rear Bracket Screws |
Copyright ©2021 by Gill Athletics.
All rights reserved.
2/18/2022
inst 730182
www.gillathletics.com
800-637-3090
Documents / Resources
 |
GILL 730182C Fusion F8 Starting Block [pdf] Instructions 730182C, 730182, 730182C Fusion F8 Starting Block, Fusion F8 Starting Block, F8 Starting Block, Starting Block |