Getac PN7160 NFC Module
General
The module is not for sale, it is intended solely for use by the grantee. The module is limited to be installed in specific host, Getac, ZX80, ZX80Y(Y= 10 characters, Y can be 0 to 9, A to Z, a to Z, “/”, “\”, “-”, “_” or blank for marketing purposes) And, the user manual integration instructions are internal confidential manufacturing documents.
List of applicable FCC rules
This device complies with Part 15.225
Summarize the specific operational use conditions
This device is for general radio use, PN7160 circuitry should not be modified. Installation of this product is in a fixed location both indoors and outdoors.
Limited module procedures
- Shielding: Shielding module
- Minimum signaling amplitude: 150 mV peak-to-peak
- Buffered modulation/data inputs: PN7160 as buffered modulation/data input.
- Power supply regulation: PN7160 is the main chip, the chip itself has the function of power supply regulation.
- This module is granted as a Limited Modular Approval. When this Module is installed into the end product, a Class II/III Permissive Change or a New FCC ID submission is required to ensure the full compliance of FCC relevant requirements.”
Trace antenna designs
Not Applicable.
RF exposure considerations
This product meets applicable national SAR limits of 1.6W/kg. These specific maximum SAR values can be found in the section of this user guide. When carrying the product or using it while worn on your body, maintain a distance of 0mm from the body to ensure compliance with RF exposure requirements. Note that the product may be transmitting even if you are not Surfing Internet. Body SAR: 1.34 W/kg
Antennas
The antenna used for this module, Brand: Smart Approach Co Ltd., Model: SR-RGBTF001, Type: Loop Antenna meets the relevant requirements.
Label and compliance information
The design of the Label
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Host manufacturer to confirm compliance with FCC requirements for the transmitter when the module is installed in the host. Must have on the host device a label showing Contains FCC ID: QYLPN7160ZX8 and IC:10301A-PN7160ZX8.
Information on test modes and additional testing requirements
This module is not tested in a stand-alone configuration. This Module is limited, requiring the host integrator to perform additional verification testing. This module has only independent emitters in the Host, and there are no multiple simultaneous emitters.
Additional testing, Part 15 Subpart B disclaimer
Compliant with Part 15 Subpart B SDoC, After the module has obtained the certification, The FCC identification number will be marked on the module body according to the regulations. The individual module is Compliant with Part 15 Subpart B as an unintentional radiator, this authorization is not inherited by the host.
Appendix – EUT Photo
Documents / Resources
 |
Getac PN7160 NFC Module [pdf] Owner's Manual PN7160ZX8, QYLPN7160ZX8, ZX80Y, PN7160 NFC Module, PN7160, NFC Module, Module |
 |
Getac PN7160 NFC Module [pdf] Instruction Manual PN7160, PN7160 NFC Module, NFC Module, Module |