ESi Controls RTP4/RF Pairing Guide
RF Reciever Pairing:
Pair in your room thermostat with your receiver.
Your RT P four RF comes prepared from the factory.
However, should the symbol arise on the screen that identifies the lack of signal, which is the circle with antenna in the middle with a line across it.
You will need to repair it on your receiver.
Press and hold the MANU button until the manual button flashes green on your room.
Thermostat Setting
- Move the slider to the off position,
- Press and hold the A button H button and plus button together.
- Keep pressing these buttons until the green light on the manual button stops flashing your room, thermostat and receiver are now repaired.
