enviolo AUTOMATIQ Wireless Controller Installation Guide

Contents hide

enviolo AUTOMATIQ Wireless Controller

CO Controller Installation

This guide shows how to add the CO Controller or handlebar-mounted controller to the handlebar of your EVELO Electric Bicycle. This applies to models equipped with the Enviolo Automatic CVT shifting system.
Note: There is no digital display on the shifter itself. You will see a flashing LED light as a power and pairing indicator. Please see the CO Controller guide for more detailed information.

Step 1: The handlebar-mounted controller attaches to the right side of the handlebar – make sure this area is clear of any other installed accessories.

Step 2: Locate the hex bolt on the bottom of the handlebar controller.
Step 3: Rotate counterclockwise until it is fully removed – do not lose this bolt.

Step 4: With this bolt removed, the hinge at the bottom will open.
Step 5: Place the handlebar controller on the bicycle handlebar.

Step 6: Insert the hex bolt removed in Step 3 and rotate clockwise until the controller is snug, but not fully tight.
Step 7: Rotate the controller on the handlebar and adjust for a comfortable position to press the buttons while riding. This can be adjusted again at a later time. Use the hex wrench to fully tighten the handlebar controller so it does not move while riding.