EMTEK Two Point Lock Single Re-Pinning Cylinder Installation Guide

Re-Pinning Cylinder (OPTIONAL)

• STEP 1
  Small hole should face down.
  
• STEP 2
  Rotate key counterclockwise 90º while pressing wire into hole.
  
• STEP 3
  Slide lever/knob off stem.
  
• STEP 4
  After re-pinning cylinder, insert lever/knob onto stem.
  Before inserting lever/knob onto stem, make sure cylinder tailpiece is vertical as shown.
  

Lock Assembly

Preparation

1. Install Bolt and Latch
   Fasten Bolt and Latch using #8 x 3/4” Wood Screws (provided).
   
2. Remove Inside Trim Plate
   STEP 1: Remove inside lever/knob by loosening set screw w/ hex wrench (provided).
   
   STEP 2: Unthread nut counterclockwise to remove from Interior Plate before installing on door.
   
3. Install Outside Trim Plate
   Fasten Outside Trim Plate using two #8-32 x 1½” Pan Head Machine Screws (provided).
   
4. Install Inside Trim Plate
   STEP 1: Install deadbolt using flat head screws.
   
   STEP 2: After interior grip is installed, tighten set screw with hex wrench (provided)
   

Copyright © 2021, Emtek Products, Inc., an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part without the express written permission of Emtek Products, Inc. is prohibited.

Documents / Resources

EMTEK Two Point Lock Single Re-Pinning Cylinder [pdf] Installation Guide Re-Pinning Cylinder, Re-Pinning, Cylinder, Two Point Lock Single Cylinder, Two Point Lock Cylinder, Single Cylinder, Two Point Lock Single Re-Pinning Cylinder

References

• User Manual