EloPOS Z30 Touch Screen and Computer
Contents
- EloPOS Z30 (1)
- 150W DC Power Adapter and cables
- M3x5mm I/O cover security screw (1)
- Stand Mounting bracket and screw (1)
- Tie-wraps (2)
I/O Connections
Installation
- Remove the cable cover door to access the I/O connections.
- Route the DC power cable through the hole in the bottom of the stand and connect it as shown. Connect other I/O cables as needed (see back page) Make sure all cables route through the plastic clip at the bottom.
- Mount the system to a table (optional). Skip to Step 6 if not mounting to a table.
Secure the mounting bracket to the table using the appropriate screw type and length. Elo suggests M4 or #10 screw diameter. - Lower the system onto the bracket and sldie it back ensuring the bracket engages the screws on the bottom side.
Documents / Resources
 |
elo EloPOS Z30 Touch Screen and Computer [pdf] Installation Guide EloPOS Z30, Touch Screen and Computer, EloPOS Z30 Touch Screen and Computer, Screen and Computer, Computer, Touch Screen |
