DSR RDM SPLITTER
OPERATION GUIDE
DSR RDM Splitter
RDM OFF/BYPASS – Depressing the switch (or shorting the jumper) will turn off RDM functionality and will ignore RDM traffic and will not reverse the DMX data line. To process and allow RDM traffic to pass through the splitter depress the switch again (or open jumper).
LED INDICATORS –
| GREEN POWER LED: | ON = power is applied |
| YELLOW DMX LED: | ON = valid DMX is Rx’ing / OFF = No valid DMX SINGLE FLASH = valid RDM forward packet was received |
| RED RDM LED: | FLICKER = RDM data being sent back to controller (line reversed) 4 SECOND PULSE = RDM OFF/BYPASS switch is on-no RDM data is not returned, data line will not reverse ON SOLID = ERROR – locked in reversal mode |
ELM Video Technology, Inc. Copyright 2023-Present
www.elmvideotechnology.com DSR-RDM-Splitter-Operation-Guide-V1.xx.vsd
Documents / Resources
 |
ELM Video Technology DSR RDM Splitter [pdf] Instructions DSR RDM Splitter, RDM Splitter, Splitter |