ELM Video Technology logo

DSR RDM SPLITTER
OPERATION GUIDE

DSR RDM Splitter

RDM OFF/BYPASS – Depressing the switch (or shorting the jumper) will turn off RDM functionality and will ignore RDM traffic and will not reverse the DMX data line. To process and allow RDM traffic to pass through the splitter depress the switch again (or open jumper).

LED INDICATORS –

GREEN POWER LED: ON = power is applied
YELLOW DMX LED: ON = valid DMX is Rx’ing / OFF = No valid DMX
SINGLE FLASH = valid RDM forward packet was received
RED RDM LED: FLICKER = RDM data being sent back to controller (line reversed)
4 SECOND PULSE = RDM OFF/BYPASS switch is on-no RDM data is not returned, data line will not reverse
ON SOLID = ERROR – locked in reversal mode

ELM Video Technology, Inc. Copyright 2023-Present
www.elmvideotechnology.com DSR-RDM-Splitter-Operation-Guide-V1.xx.vsd

Documents / Resources

ELM Video Technology DSR RDM Splitter [pdf] Instructions
DSR RDM Splitter, RDM Splitter, Splitter

References

Leave a comment

Your email address will not be published. Required fields are marked *