CREALITY Auto Bed Leveling Sensor for 3D Printer

Packing List

BL Touch	Connectors	Tie
Rack	Pinboard A	M3X82PCS
M3X6 2PCS	ISP Pinboard	Burner

Circuit Principle

Update Firmware

1. Connect ISP Pinboard and Burner.
2. Open the control box and find out the mainboard
3. Insert ISP Pinboard into the mainboard 2X3 pins as the sign shows.
4. Insert the burner into computer USB port.

1. Open progisp.exe
2. Select Chip ATmega1284p.
3. Click … —> Set Low Value=D6, HighValue=DC, ExtValue=FD—>Click Write and close the window.
4. Load Flash—>Select .hex 1ile.
5. Click Auto to update firmware, wait until it 1inishs, then close.
6. Unplug the ISP Pinboard from mainboard.

Install BL Touch

1. Insert connectors into 5 Pin Port.
   
2. Install BL Touch on the rack with 2 M3X6 screws
   
3. Loosen all fan cover screws, Install the frame on the corresponding position with 2 M3X8 screws
   
4. Secure the cable to the guide tube and cable with a cable tie and bypass the rear side of the gantry.
   

Circuit Wiring

1. Unplug the screen cable, connect the Pinboard A to the screen port (EXP1).
2. Insert the screen cable into 10 pins port.
3. Insert the connectors to the 3 pins port as the sign shows.
4. Unplug the Z limit switch(Z-stop port),and insert the connectors.

Platform Adjustment

1. Prepare–>Auto home, and wait until it stops.
   
2. Prepare–>Move axis–>Move Z–>Move 0.1 mm–>Rotate the knob until the distance between them is about 0.2mm (as a sheet of A4 paper) , write down the value of A.
   
3. Rotate the knob until the distance between them is about 0.2mm (as a sheet of A4 paper) , write down the value of A (For example, figure 3)
   
   
4. Control–>Motion–>Z Offset–>write down the value of B, then rotate the knob until it comes out as: C=B+A. Return Control and Select Store settings.
   

Software Settings

1. Open Cura
2. Settings–> Printer-Manage Printers
3. Machine Settings
4. Change”G28″to”G28 G29″

Scan QR code to view detailed instruction

SHENZHEN CREALITY 3D TECHNOLOGY CO.,L TD.
11F & Room 1201,Block 3,JinChengYuan,Tongsheng Community, Dalang, Longhua District,Shenzhen,China,518109
Official Website: www.creality.com
Tel: +86 755-8523 4565
E-mail: info@creality.com / cs@creality.com

Documents / Resources

CREALITY Auto Bed Leveling Sensor for 3D Printer [pdf] User Guide CREALITY, Bed Leveling Sensor, 3D Printer

References

• User Manual