RS35 UHF RFID Reader
“
Product Specifications:
- Compliance: Part 15 of FCC Rules
- RF Exposure: Meets government requirements
- SAR Limit: 1.6 W/kg
- FCC ID: Q3N-RUHFII
Product Usage Instructions:
1. FCC Compliance:
This device complies with Part 15 of the FCC Rules. It must not
cause harmful interference and should accept any interference
received.
2. RF Exposure Warning:
This device meets the government’s requirements for exposure to
radio waves. It is designed not to exceed emission limits for
exposure to RF energy set by the FCC.
3. Specific Absorption Rate (SAR):
The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are
conducted using standard operating positions accepted by the FCC
with the EUT transmitting at specified power levels in different
channels.
The FCC has granted Equipment Authorization for this device with
reported SAR levels evaluated as in compliance with FCC RF exposure
guidelines. SAR information can be found on the FCC website under
the Display Grant section after searching the FCC ID:
Q3N-RUHFII.
Frequently Asked Questions (FAQ):
Q: What should I do if I experience interference while using
the device?
A: If you experience interference, try moving the device to a
different location or adjusting its positioning. Ensure no other
electronic devices are causing interference.
Q: How can I check the SAR information for this device?
A: You can find SAR information on the FCC website by searching
the FCC ID: Q3N-RUHFII under the Display Grant section.
“`
CAUTION:
USA (FCC):
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications . However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/ TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
RF Exposure warning This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
The exposure standard employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the EUT transmitting at the specified power level in different channels.
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm after searching on FCC ID: Q3N-RUHFII.
Documents / Resources
 |
CipherLab RS35 UHF RFID Reader [pdf] User Guide RS35, RS35 UHF RFID Reader, UHF RFID Reader, RFID Reader, Reader |