Camplex PULLEYE-1 Pulling Eye
Specifications
- Product Name: Camplex PULLEYE-1 or PULLEYE-2
- Country of Origin: USA
- US ECCN: EAR99
- HTS Code: 8544.42
- US Dept. of Commerce CCATS: N.a
Tools Required
- Electrician Tape (Not Included with PULLEYE-1 or PULLEYE-2)
Installation of Pulling Eye on Multi Fiber Cable
- Step 1
Tape down the central strength legs behind the fanout point.
- Step 2
Cross the legs to form a weave pattern. The length of the weaving depends on the primary cable diameter. Tie it off and trim the excess.
- Step 3
Using electrician tape, wrap the legs firmly.
- Step 4
Pull back the Techflex to insert the connectors.
- Step 5
Bring the Techflex over the legs and wrap it with electrician tape.
- Step 6
On final inspection, the tension should occur at the core legs.
Contact Information
- Email: sales@camplex.com
- Website: www.camplex.com
- A Division of Tower Products Incorporated
- Revision #01
FAQs
Q: What should I do if the pulling eye installation is too tight?
A: If the tension is too high when installing the pulling eye, carefully release some of the tension from the core legs before completing the installation.
Q: Can I use regular tape instead of electrician tape for this installation?
A: It is recommended to use electrician tape for this installation as it provides the necessary durability and strength required for securing the central strength legs.
Export Information
Country of Origin: USA
US ECCN: EAR99
HTS Code: 8544.42
US Dept. of Commerce CCATS: N.a
A Division of Tower Products Incorporated
Revision #01
sales@camplex.com
www.camplex.com
Documents / Resources
 |
Camplex PULLEYE-1 Pulling Eye [pdf] Installation Guide PULLEYE-1 Pulling Eye, PULLEYE-1, Pulling Eye, Eye |
