Work. Flow. Home.
Basalt
Monitor stand extension for Tenon Workspace
Placing cables inside Basalt
Unscrew the center bolt.
Specifications
Dimension: 510 x 120 x 100 mm
Weight: 5.4lbs / 2.4kg
1.2 Remove the bottom cap by unscrewing the two bolts
1.3 Lift up the front lid.
You can now insert your display cables by sliding them underneath the lid.
1.4 Close the lid.
1.5 Screw back the bottom lid.
Attaching a monitor to Basalt
Twist Basalt to the left at the VESA mount hinge. Then screw the two screws on the right of the VESA mount. Repeat for opposite side.
Assembling Basalt to Tenon
Unscrew the adapter from the bottom cap.
3.2 Place the adapter into the rear frame of Tenon.
3.3 Lower Basalt through the desktop slot onto the adapter from above.
Keep Basalt perfectly vertical.
3.4 Fasten the middle bolt to secure both parts together.
Adjusting Tilt
If Basalt is not perfectly upright after assembly, the two additional plastic screws may be used to adjust Basalt’s tilt.
Screw the screws into the adapter until they hit the frame, after this point each turn of the screws will affect Basalt’s upright angle.
www.gobeflo.com
© Copyright 2024 Nonet Inc. or its subsidiaries.
All rights reserved.
Documents / Resources
 |
beflo Basalt Monitor Stand Extension [pdf] Instruction Manual Basalt Monitor Stand Extension, Monitor Stand Extension, Stand Extension |