ANTEC C8 White Argb Fans Not Included
- Antee, Inc. is the global leader in high-performance computer components and accessories for the gaming, PC upgrade, and Do-It-Yourself markets.
- Founded in 1986, Antee is recognized as a pioneer in the industry and has maintained its position as a worldwide market leader and international provider of quiet, efficient, and innovative products.
- Antee has also achieved great success in the distribution channel, meeting the demands of quality-conscious system builders, VARs, and integrators.
CONTENTS AND ACCESSORIES
ACCESSORY BOX CONTENTS
Toolbox Contents
PRODUCT INTRODUCTION
CASE OVERVIEW
I/O PANEL
PARTS
- A Case Body
- B Full Mesh Side Panel
- C Tempered Glass Front Panel
- D Full-Sized Pull-Out Dust Filter
- E Top Panel
- F Tempered Glass Side Panel
- G 120mm Fan Bracket
- H 140mm Fan Bracket
- I PSU Bracket
- J 2.5″ SSD Tray
- K 3.5″ HDD Cage
- L Airflow Partition
- M Tranquil Reverse 160mm ARGB PWM Fan
- N Tranquil 140mm ARGB PWM Fan
CASE SPECIFICATIONS
FAN SPECIFICATIONS
[A] Tranquil Reverse 160mm ARGB PWM Fan
- Fan Type: PWM Fan
- Fan Speed: 450 150~1500$150 RPM
- Rated Voltage: FAN: DC 12 V / LED: DC 5 V
- Operating Voltage: DC 7.0~13.2
- Rated Current: FAN: 0.35 A / LED: 0.40 A
[B] Tranquil 140mm ARGB PWM Fan
- Fan Type: PWM Fan
- Fan Speed: 450100~1500‡150 RPM
- Rated Voltage: FAN: DC 12 V / LED: DC 5 V
- Operating Voltage: DC 7~13.8 V
- Rated Current: FAN: 0.22 A / LED: 0.30 A
INSTALLATION GUIDE
REMOVE THE FRONT, TOP, AND SIDE PANEL
[A] TOP & SIDE PANEL
[B] FRONT PANEL
MOTHERBOARD INSTALLATION
VGA / PCI-EXPRESS CARD INSTALLATION
AIRFLOW PARTITION REMOVAL
POWER SUPPLY INSTALLATION
HARD DISK INSTALLATION
[A] INSTALLING A 3.5″ HARD DISK DRIVE
[B] INSTALLING A 2.5″ SOLID STATE DRIVE
FAN INSTALLATION
[A] SIDE & TOP & REAR FAN
- [B] BOTTOM FAN : 120MM
- [C] BOTTOM FAN: 140MM
- [D] BOTTOM FAN: 160MM
LIQUID COOLING RADIATOR INSTALLATION
- [A] TOP RADIATOR
- [B] BOTTOM RADIATOR
- [C] SIDE RADIATOR
- [D] REAR RADIATOR
ROUTING SUGGESTION
ARGB & PWM FAN HUB CONNECTIONS
2 x 3-Pin ARGB and 2 x 4-Pin PWM headers already connected with the pre-installed fans.
For the additional fan connection, the current of each ARGB or PWM connection must be less than 1.5A.
CABLE MANAGEMENT IN THE BACK
Documents / Resources
 |
ANTEC C8 White Argb Fans Not Included [pdf] Instructions C8 White Argb Fans Not Included, C8, White Argb Fans Not Included, Fans Not Included, Not Included, Included |