Divine 60 UV LED Luminaire
Instruction Manual
INSTALLATION INSTRUCTIONS
DIVINE™ 60 UV
Divine 60 UV LED Luminaire
The unit must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
This device falls under class one and must be grounded!
STEP 1
CABLE GLAND
1A For bottom connection
Inlets for power and data from bottom side of the luminaire.
1B For side connection
Inlets for power and data from side of the luminaire.
STEP 2
UNCOVER JUNCTION BOX
Uncover junction box located on the bottom side of luminaire.
STEP 3 CONNECTION
1 Strip these lenghts for cable connections
| Power Connection | 9mm |
| Data Connection | 7mm |
Connection – colour coding
To connect the Divine 60 UV to mains and a DMX controller, use a 5-cored cable Flamar Li9YC11Y. The 3 colors serve for the power supply and 2 shielded cores are intended for DMX connection.
Power and Data Connection
| WIRE | POWER CONNECTION | WIRE | DATA CONNECTION |
| Brown | L | White | Data – (D-) |
| Blue | N | Red | Data + (D+) |
| Yellow/Green | Ground | Shielding | Data Ground (0V) |
3A Wiring connection (control menu inside)
3B Wiring connection (control menu outside)
STEP 4 CONTROL MENU
1A Control menu inside
1B Control menu outside
STEP 5 CLOSE JUNCTION BOX
Before applying the torque, make sure the thread is clean and functional.
STEP 6 CABLE GLAND INSTALLATION
Use wrench size 24 for cable gland M20x1.5
Use wrench size 16 for cable gland M12x1.5
Install Cable glands individually!
We recommend to apply an adequate layer of the paste LOCTITE 5331 on the plastic holder of the cable gland before inserting in into the body of the gland and an adequate layer of the paste LOCTITE 577 on the thread ofthe gland body.
Failure to properly install cable glands will result in failure of the water tight seal!
STEP 7.A INSTALLATION WITH SURFACE MOUNT ADAPTOR
Mount the adaptor using 6 mounting screws.
Use fasteners that are appropriate for use with your mounting surface. 
Drill holes to the surface according to holes spacing. Mount Divine via mounting holes on the surface.
STEP 7.B INSTALLATION WITH SET OF RUBBER FEET
STEP 7.C INSTALLATION WITH C-CLAMP ADAPTOR
TYPE OF ACCESSORIES
Adaptor Black Glass
STEP 8
INSTALLATION OF ACCESSORIES
Unscrew two screws and split accessory to two parts. Place each part onto the luminaire´s head and screw them together.
Secure accessory by 4 screws with spring washer at the back side of luminaire´s head.
STEP 9 HEAD POSITION ADJUSTMENT
Release locking screw on each sides. Angle fixture to desired position and tighten locking screw on each sides.
www.anolis.eu www.anolislighting.com
ROBE lighting s. r. o.
Palackeho 416 | 757 01 Valasske Mezirici
Czech Republic | Tel.: +420 571 751 500
E-mail: info@anolis.eu
VERSION 1 / 10_05_2021
Documents / Resources
 |
ANOLiS Divine 60 UV LED Luminaire [pdf] Instruction Manual Divine 60 UV LED Luminaire, Divine 60 UV, LED Luminaire, Luminaire |
