ANALOG DEVICES-LOGO

ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing

ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing-FIG1

POWER SOLUTIONS FOR PRECISION TECHNOLOGY SIGNAL CHAINS

PRECISION CURRENT SENSING
Generic Signal Chains for Current Measurement Contactless Sensing – Hall 5V Output

PRECISION CURRENT SENSING CATALOG

GENERIC SIGNAL CHAINS FOR

CURRENT MEASUREMENT

 

Input Voltage

5V
12V
24V
APPENDIX Parts Guide
Power Requirements

USER GUIDE

This document is interactive. You can click on any underlined text to navigate through the document.

For the table of contents and resources

ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing-FIG4

For the individual pages

ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing-FIG5

APPENDIX

ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing-FIG6 ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing-FIG7 ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing-FIG8

PART # DESCRIPTION
ADP7118 20 V, 200 mA, Low Noise, CMOS LDO Linear Regulator
ADP225 Dual, 300 mA Output, Low Noise, High PSRR Voltage Regulators, Adj. Output: 0.5 V to 5 V
LT3023 Dual 100mA, Low Dropout, Low Noise, Micropower Regulator
LT8338 40V, 1.2A Micropower Synchronous Boost Converter with Pass-Thru
LT8604 High Efficiency 42V/120mA Synchronous Buck

POWER REQUIREMENTS

 

PARAMETER

STAGES Amplifier Filter ADC Reference
Part # ADA4807-1 AD4000 ADR4550
Pin +VS -VS VDD VIO IN
Supply Voltage V 5 0 1.8 3.3 7 (or 12)
Supply Current mA 0.95 0.95 5.42 0.16 0.95
PSRR dB 72 (1MHz) 47 (1MHz) 75 (200kHz) 60 (1MHz)
  • Note 1: The supply currents indicated are the maximum quiescent current of the supply rails. For overall full load or short circuit current specifications, refer to the datasheets of the signal chain components.
  • Note 2: The supply voltages indicated are the values for typical applications.
  • Note 3: Consult the corresponding datasheets for details on: (1) power supply rejection ratio (PSRR) and (2) power dissipation.
  • Note 4: The actual supply current requirement shall be multiplied depending on the number of channels on the signal chain.

©2022 Analog Devices, Inc. All rights reserved. Trademarks and registered trademarks are the property of their respective owners.

Documents / Resources

ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing [pdf] User Guide
Generic Signal Chains for Current Measurement Contactless Sensing, Generic Signal Chains, Current Measurement Contactless Sensing, Measurement Contactless Sensing, Contactless Sensing, Contactless
ANALOG DEVICES Generic Signal Chains for Current Measurement Contactless Sensing [pdf] User Guide
Generic Signal Chains for Current Measurement Contactless Sensing, Generic Signal Chains, Current Measurement Contactless Sensing, Signal Chains, Chains

References

Leave a comment

Your email address will not be published. Required fields are marked *