ANALOG-LOG

ANALOG DEVICES Generic Signal Chains for Current Measurement Shunt

ANALOG-DEVICES-Generic-Signal-Chains-for-Current-Measurement-Shunt-PRODUCT-IMG

PRECISION CURRENT SENSING
Generic Signal Chains for Current Measurement Shunt: Common-Mode Voltage Level Up to 18V
ANALOG-DEVICES-Generic-Signal-Chains-for-Current-Measurement-Shunt-FIG- (1)

USER GUIDE

This document is interactive. You can click on any underlined text to navigate through the document

For the resources:ANALOG-DEVICES-Generic-Signal-Chains-for-Current-Measurement-Shunt-FIG- (2) ANALOG-DEVICES-Generic-Signal-Chains-for-Current-Measurement-Shunt-FIG- (3)

For the individual pages:ANALOG-DEVICES-Generic-Signal-Chains-for-Current-Measurement-Shunt-FIG- (4)

Precision Current SensingANALOG-DEVICES-Generic-Signal-Chains-for-Current-Measurement-Shunt-FIG- (5).

Generic Signal Chain for Current Measurement
Shunt: Common Mode Voltage Up to 18V

Non-isolated

  • 1-Channel
PART # DESCRIPTION
ADP7118 20 V, 200 mA, Low Noise, CMOS LDO Linear Regulator
LT3032-15 Dual 150mA Positive/Negative Low Noise Low Dropout Linear Regulator
ADP5070 1 A/0.6 A, DC-to-DC Switching Regulator with Independent Positive and Negative Outputs
LT8330 Low IQ Boost/SEPIC/Inverting Converter with 1A, 60V Switch
LT8604 High Efficiency 42V/120mA Synchronous Buck

POWER REQUIREMENTS

 

PARAMETER

STAGES Instrumentation Amp Filter ADC Reference
Part # AD8421 AD4000 ADR4550
Pin +VS -VS   VDD VIO IN
Supply Voltage V 15 -15 1.8 3.3 5.1 to 15
Supply Current mA 2.6 2.6 5.4 0.15 0.95
PSRR dB 20 (500kHz, G=1) 50 (500kHz, G=1) 65 (700kHz) 60 (1MHz)
  • Note 1:
    The supply currents indicated are the maximum quiescent current of the supply rails. For overall full load or short circuit current specifications, refer to the datasheets of the signal chain components.
  • Note 2:
    The supply voltages indicated are the values for typical applications.
  • Note 3:
    Consult the corresponding datasheets for details on: (1) power supply rejection ratio (PSRR) and (2) power dissipation.
  • Note 4:
    The actual supply current requirement shall be multiplied depending on the number of channels on the signal chain.

Documents / Resources

ANALOG DEVICES Generic Signal Chains for Current Measurement Shunt [pdf] User Guide
Generic Signal Chains for Current Measurement Shunt, Generic Signal Chains, Current Measurement Shunt, Measurement Shunt, Shunt

References

Leave a comment

Your email address will not be published. Required fields are marked *