Quick Start Guide
Install OBDwiz software
Point your browser to obdlink.com/software
Download “OBDwiz for Windows”. Run the installer to set up the software.
Connect OBDLink SX to the PC
The LED will turn yellow when you connect OBDLink SX to the PC’s USB port.
— Red LED? Drivers were not installed properly.
Plug OBDLink SX into the OBD port
The OBD port is usually found on the driver’s side, under the dash.
Turn ignition to Key On, Engine Off
The LED will turn green.
Vehicles with push button start: press the button without stepping on the brake pedal.
— Yellow LED? Check for blown fuses.
(OBD port, auxiliary port, and the cigarette lighter).
Launch OBDwiz software
Click Start > Programs > OBDwiz > OBDwiz.
Activate OBDwiz
Click the ‘Connect’ button:
Follow the prompts to activate the software and begin using your OBDLink SX.
– Need help? Go to obdlink.com/support or scan the QR code
Thank you for your purchase!
If you like OBDLink SX
please post your review on
CE Declaration of Conformity
3/23/2018
OBD Solutions LLC hereby confirms that the product branded
“OBDLink” complies with:
• REACH EC No 1907/2006 – SVHC
• ROHS Directive 2011/65/EU
• CE Conformity date of issue: September 16, 2015
Documents / Resources
 |
amazon OBDLink SX USB 425801 Diagnostic Interface and OBDWiz Software for Windows [pdf] User Guide OBDLink SX, USB 425801 Diagnostic Interface and OBDWiz Software for Windows, OBDLink SX USB 425801 Diagnostic Interface and OBDWiz Software for Windows, Interface and OBDWiz Software for Windows, OBDWiz Software for Windows |
