MyChron5S
GPS Lap Timer and Water Temperature Sensor
FAQ
Instruction Manual
Configuring
Setting temperatures in “Manual” mode
Question:
Can I configure the temperature setting in Manual mode on MyChron5/5S?
Answer:
You can only configure this setting on MyChron5S.
To configure the temperature setting in manual mode, you have to access the main menu of the device – System Setting – Temperature Setup.
Harness Type: indicate the extension of the sensors connected to the MyChron5S, it could be:
- TC/TR – Thermocouple – Thermo-resistor
- TR/TR – Thermo-resistor – Thermo-resistor
- TC/TC – Thermocouple – Thermocouple
Temperature IN1/IN2: configure the two sensors by inserting the correct labels.
Release 1.00 – July 5th, 2022
Documents / Resources
 |
AiM MyChron5S GPS Lap Timer and Water Temperature Sensor [pdf] Instruction Manual MyChron5S GPS Lap Timer and Water Temperature Sensor, MyChron5S, GPS Lap Timer and Water Temperature Sensor |
