Aeropulse Fusion Apollo Marine Amplifier Unbox Installation Guide
Step 1
Insert the sensor or battery capsule at a 30-degree angle into the designated slot. Once aligned, press down on the top side of the capsule to secure it in place.
Step 2
Position the cover over the capsules and press down firmly on the upper part to ensure a secure ft.
Step 3
Attach the small bracket onto the device and secure it using three screws.
Step 4
Mount the larger bracket onto the wall and secure it with screws
| EU / CHN | US |
 |
 |
Step 5
Connect the necessary power and connectivity cables:
- Power Cable
- Connect 10-30V DC or 24V AC to the +/- terminals on the connectivity port.
- For Poe, connect to the Ethernet port
- Connectivity Cables
- Connect Modbus or BACnet cables to the A/B terminals on the connectivity port.
- Connect the Ethernet cable to the Ethernet port.
Step 6
Slide the device vertically into the wall-mounted brackets until securely positioned.
| EU / CHN | US |
 |
 |
Documents / Resources
 |
Aeropulse Fusion Apollo Marine Amplifier Unbox [pdf] Installation Guide Fusion Apollo Marine Amplifier Unbox, Apollo Marine Amplifier Unbox, Marine Amplifier Unbox, Amplifier Unbox |
