MW APC-16 series 16W Single Output Switching Power Supply
Features
- Constant current mode design
- Universal AC input / Full range
- Protections:Short circuit/Over voltage
- Fully isolated plastic case
- Small and compact size
- Cooling by free air convection
- Class II power unit, no FG
- Class 2 power unit
- Pass LPS
- IP42 design
- Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)(Note.6)
- 100% full load burn-in test
- Low cost / High reliability
- 2 years warranty
GTIN CODE
MW Search: https://www.meanwell.com/serviceGTIN.aspx
SPECIFICATION
| MODEL | APC-16-350 | APC-16-700 | |
|
OUTPUT |
RATED CURRENT | 350mA | 700mA |
| DC VOLTAGE RANGE | 12~48V | 9~24V | |
| RATED POWER | 16.8W | 16.8W | |
| RIPPLE & NOISE (max.) Note.2 | 300mVp-p | 250mVp-p | |
| VOLTAGE TOLERANCE Note.3 | ±5.0% | ||
| CURRENT ACCURACY | ±8.0% | ||
| LINE REGULATION | ±1.0% | ||
| LOAD REGULATION | ±3.0% | ||
| SETUP, RISE TIME | 3000ms, 200ms / 230VAC 3000ms, 200ms / 115VAC at full load | ||
| HOLD UP TIME (Typ.) | 20ms/230VAC 12ms/115VAC at full load | ||
|
INPUT |
VOLTAGE RANGE Note.4 | 90 ~ 264VAC 127 ~ 370VDC | |
| FREQUENCY RANGE | 47 ~ 63Hz | ||
| EFFICIENCY(Typ.) | 84% | 83% | |
| AC CURRENT | 0.3A/230VAC;0.5A/115VAC | ||
| INRUSH CURRENT(Typ.) | COLD START 45A(twidth=210μs measured at 50% Ipeak) at 230VAC | ||
| MAX. No. of PSUs on 16A CIRCUIT BREAKER | 13 units (circuit breaker of type B) / 23 units (circuit breaker of type C) at 230VAC | ||
| LEAKAGE CURRENT | 0.25mA / 240VAC | ||
| PROTECTION | OVER VOLTAGE | 50.4~ 60V | 27.6~ 33.5V |
| Protection type : Shut off o/p voltage, clamping by zener diode | |||
|
ENVIRONMENT |
WORKING TEMP. | -30 ~ 70℃(Refer to “Derating Curve”) | |
| WORKING HUMIDITY | 20 ~ 90% RH non-condensing | ||
| STORAGE TEMP., HUMIDITY | -40 ~ +80℃, 10 ~ 95% RH | ||
| TEMP. COEFFICIENT | ±0.2%/℃ (0 ~ 50℃) | ||
| VIBRATION | 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes | ||
| SAFETY & EMC
(Note 5) |
SAFETY STANDARDS Note.7 | UL8750,CSA C22.2 No.250.0-08, BIS IS15885, EAC TP TC 004,BS EN/EN 62368-1 approved | |
| WITHSTAND VOLTAGE | I/P-O/P:3.75KVAC | ||
| ISOLATION RESISTANCE | I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH | ||
| EMC EMISSION | Compliance to BS EN/EN55032,BS EN/EN61000-3-2,BS EN/EN61000-3-3, EAC TP TC 020 | ||
| EMC IMMUNITY | Compliance to BS EN/EN55035,BS EN/EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), EAC TP TC 020 | ||
|
OTHERS |
MTBF | 6411.4K hrs min. Telcordia SR-332 (Bellcore) ; 1092.9K hrs min. MIL-HDBK-217F (25℃) | |
| DIMENSION | 77*40*29(L*W*H) | ||
| PACKING | 0.1Kg; 120pcs/14Kg/1.06CUFT | ||
| NOTE | 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristic for more details.Please connect L line to the positive pole and N line to the negative pole under DC input. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. This product is not intended for LED lighting luminaire applications in the EU.(In the EU the LPF/NPF/XLG series are recommended.) 7. The model certified for CCC(GB19510.14, GB19510.1, GB17743 and GB17625.1) is an optional model . Please contact MEAN WELL for details. 8. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft). 9. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf ※ Product Liability Disclaimer：For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx |
||
Mechanical Specification
Block Diagram
Derating Curve
Static Characteristics
Documents / Resources
 |
MW APC-16 series 16W Single Output Switching Power Supply [pdf] Instruction Manual APC-16 series, 16W Single Output Switching Power Supply, APC-16 series 16W Single Output Switching Power Supply, Output Switching Power Supply, Power Supply |
