CF 45 CL Robotic Pool Cleaner
Usage Instructions
- Install the scrapers onto the robot for better cleaning performance.
- Ensure the robot is fully charged before use.
- Place the robot in the pool water.
- Press the power button to start the cleaning cycle.
- Monitor the robot as it cleans the pool floor.
- After each use, clean the filters and ensure all parts are properly stored to maintain the robot’s efficiency.
READ INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
The CF Electric Cleaners manual is designed to give you all the information you need for optimum installation, use and maintenance. You must familiarise yourself with this document and keep it in a safe, known place for future reference.
SAFETY INSTRUCTIONS
- Read the manual carefully, and use the cleaner according to the manual. We are not liable for loss or injury caused by improper use.
- Only use the accessories recommended or sold by the manufacturer.
- This model only applies to swimming pools with a flat floor.
- Do not allow children to ride on the cleaner or play with it as a toy.
- Use the original and authorized charging adapter only.
- The adapter cord should only be repaired or replaced by a qualified electrician.
- Do not turn on the cleaner when it is out of water.
- The charging adapter must be connected to a leakage-protected and earthed socket when charging.
- Do not operate the cleaner when there are people in the pool.
- Always clean and wash the filter tray after use.
- Turn off the cleaner when maintaining, cleaning, or when it is not in use.
- The cleaner should be stored in a cool and ventilated place, away from direct sunshine.
- While charging, the cleaner should be kept in a cool place, and not be covered with anything to prevent damage of internal electrical components caused by overheating.
- Only certified professionals can disassemble the sealed driving kit of the cleaner.
- Do not operate the cleaner while the pool filter is running.
- Oil seals for the motor contain grease, which may cause water pollution if grease leaks occur.
- Due to the limitation of battery capacity, the cleaner is only suitable for swimming pools with a size up to 525 ft2 (50m2), otherwise, the cleaning effect will be affected.
- When the cleaner is stored for a long time, it should be charged every three months to maintain battery life. Please use the original and authorized charging adapter only. If the cleaner is not charged for a long time, battery voltage will be lower than the over-discharge protection voltage due to the self-discharge of the battery, which may cause fatal damage.
- Do not use or store the cleaner near any heat source.
- Do not pierce the shell of the cleaner with nails or other sharp objects. Do not hammer, impact, or throw the cleaner
- Make sure the charging socket is dry before charging.
SAFETY ADVICE
INTRODUCTION
- The environmentally-friendly robotic pool cleaner CF 45 CL is a new type of rechargeable automatic cleaner that filters the pool water and gets rid of particles without replacing the pool water.
PACKING LIST
| Item | Name | Qty (pc/pcs) | Remark |
| 1 | Cleaner | 1 | In carton |
| 2 | Charger | 1 | In carton |
| 3 | Flipper | 1 | In carton |
| 4 | Retrieving hook | 1 | In carton |
| 5 | Screw | 2 | In a plastic bag |
| 6 | Scraper | 2 | In a plastic bag |
| 7 | User manual | 1 | In a plastic bag |
| 8 | Quick guide | 1 | In carton |
PRODUCT DESCRIPTION
SPECIFICATIONS
| Product Name | Robotic Pool Cleaner |
| Model | CF 45 CL |
| Rated Working Voltage | 11.1V |
| Power | approx. 30W |
| Working Cycle | max. 50mins |
| Rated Input Voltage of Adapter 1 | 100Vac-240Vac |
| Rated Input Frequency of Adapter | 47Hz-63Hz |
| Rated Output Voltage of Adapter | 12.6Vdc |
| Rated Output Current of Adapter | 1A |
| Battery Capacity | 2600mAh |
| Charging Time | 3-4 H |
| Cleaning Surface | max. 525ft2 / 50m2 |
| Filter Capability | approx. 32gal/min (120L/min) |
| Filter Density | 180 μm |
| Moving Speed | approx. 52.5ft/min (16m/min) |
| Water Depth | max. 8.2 ft / 2.5m |
| IP Grade | IPX8 |
| Pool Water Temperature | 50°F-95°F / 10°C-35°C |
| Charging Environment Temperature | 41°F-95°F / 5°C-35°C |
| Storage Temperature | 41°F-95°F / 5°C-35°C |
| Product Weight | 7.9 lb / 3.6kg |
| Product Size | 13.4 (L) * 13.8 (W) * 13.0 (H) in /
340 (L) * 350 (W) * 330 (H) mm |
INSTRUCTION FOR USE
ASSEMBLY BEFORE USE
- Attach the flipper and fix it with the screws provided.
Note: The installation direction of 2 screws is opposite.
- Install the scrapers to enhance the suction effect if the pool floor is full of debris or particles. It is not recommended to install the scrapers if the pool bottom is uneven or full of pits, this avoids the cleaner from getting stuck by the rough floor.
- Attach the retrieving hook to a standard pool pole (not included).
OPERATION
Charge the battery
Fully charge the cleaner before each use. Attach the charging connector to the charging socket at the bottom of the cleaner. Place the cleaner in its upright position and, then plug the charger into the main electrical outlet. The indicator lamp on the charger shall turn red when charging. It should turn green once fully charged.
NOTE: The robotic cleaner must be charged indoors.
NOTE: It is strictly forbidden to face the bottom up to prevent the swing plate from being crushed when charging.
NOTE: Clean and dry the charging socket before charging.
Purge out the air
- Hold the robotic cleaner with two hands and submerge it in the pool. Rotate the cleaner until no air bubbles is coming out.
Turn on the power
- While keeping the entire robotic cleaner underwater, switch on the product by pressing the power button located at the bottom. Water will begin to flow out from the nozzle after 5 seconds.
Release the cleaner
- Hold the robotic cleaner in its upright position and slowly release the product. The product shall slowly sink to the pool floor. In case the cleaner is flipped upside down, use the floating handle to correct its orientation.
Let it clean
- The robotic cleaner shall run around the pool floor and vacuum the debris automatically for max. 60 minutes. It will automatically reverse when it touches the wall.
- The cleaner will move to the pool wall automatically and stop running when it runs out of battery.
Retrieve the cleaner
- To retrieve the robot, grasp the flipper and pull it out of the water and away from the pool. Power off the robot. Use the retrieval hook if needed.
BUZZER NOTE
| Status | Description |
| Power on | Beep before not fully immersed in the water; Stop beeping after fully immersed in the water |
| Power off | Stop beeping |
MAINTENANCE & ADJUSTMENTS
CLEAN AFTER USE
- Open all lock buckles, detach the top cover, and remove the filter screen.
- Rinse off all the dirt and debris with running water.
- Wipe the robotic cleaner with a clean cloth and let it air dry.
ADJUSTMENT OF RUNNING PATTERN
- This robotic cleaner comes with 2 adjustable wheels. By modifying the combination of these 2 adjustable wheels, it will change the running pattern of the cleaner.
- To adjust the wheel, open the lock buckles and remove the top cover. Locate the 2 adjustable wheels. Detach the wheel by pushing the wheel stem catch. Select the correct combination and insert the wheel until the catch clicks.
Combinations:
- A – C: for most types of pool (factory setting)
- B – C: Smaller rebounding angle than A – C
- C – C: Minimum maneuvering (For rectangular or longer pool)
- A – B: For round pools
POOL WATER CONDITIONER
Remark: The pool water condition must be within the following parameters:
- PH: 7.0-7.4
- Temperature: 50°F -95°F (10°C -35°C )
- Salt: Max. 5,000 ppm
- Chlorine: Max. 2 ppm
WARRANTY
- This product is covered by warranty for 24 months (only for the driving kit and control box kit) from the date of purchase. Consumable parts are beyond warranty, which include Filter Tray/ Brush/ Wheels/Nozzles.
- This warranty is voided if the product has been altered, misused, or repaired by unauthorized personnel.
- The warranty extends only to manufacturing defects and does not cover any damage resulting from mishandling of the product by the owner.
- The order number or record must be presented for any claim or repair during the warranty period.
| Environmental Programmes, WEEE European Directive |
| Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly recycles electrical and electronic equipment. Do not dispose of them in unsorted waste bins. For items containing removable batteries, remove batteries before disposing of the product. |
CONTACT
- CF GROUP DEUTSCHLAND GMBH BAHNHOFSTRASSE 68
- 73240 WENDLINGEN – GERMANY
- INFO.DE@CF.GROUP
- WWW.CF-GROUP/DEUTSCHLAND
- +49 (7024) 4048 – 100
FAQ
TROUBLE SHOOTING
| Issue | Scénario | Possible reason | Solution |
| The buzzer does not beep, or the impeller does not work when the cleaner is out of water. | – | Battery level is low. | Recharge the battery. |
| – | Internal fault | Call customer service | |
| The buzzer still beeps, or the impeller does not work when the cleaner is in the water. | – | Internal fault | Call customer service |
| The cleaner does not change direction when hitting the pool wall. | The flipper does not flip forward when approaching the pool wall. | The flipper is stuck and does not turn freely. | Hose off the dirt around the hinge of the flipper. Make sure the flipper turns freely. |
| The LED indicator does not light up when the charger is plugged in. | – | Faulty charger | Call customer service and request a replacement charger. |
| The cleaner does not vacuum the entire pool floor. | The cleaner keeps bouncing in the same direction, and some areas are always missed. | Improper running pattern setting | Try different running patterns. Refer to the “Adjustment of running pattern” section of the manual. |
| Irregular pool shape | |||
| The pool filtration system is on. | The water current inside the pool affects the running of the cleaner. | Turn off the pool’s filter pump when using this product. |
Documents / Resources
 |
CF CF 45 CL Robotic Pool Cleaner [pdf] Instruction Manual CF 45 CL Robotic Pool Cleaner, CF 45 CL, Robotic Pool Cleaner, Pool Cleaner, Cleaner |